answersLogoWhite

0

Chevy Corvette

Launched in 1953, Chevy Corvette is a sports car manufactured by General Motor’s Chevrolet division. Harley Earl designed its first model, a convertible. It is Commonwealth of Kentucky’s official sports car.

4,587 Questions

How do you find which one is the bad fuel injector in 1989 corvette?

LOW OHM READING - MEANS BAD INJECTOR COIL ECM FIRES FOUR AT A TIME ON 89'S IN LINE 14 -16 OHMS IS NORMAL LOWER OHMS RAISES AMPS BEYOND ECM CAPACITY AND ALL FOUR CAN MISFIRE

Where is the knock sensor 1982 Corvette?

Down in front of starter screwd into engine block right hand side , big round brass with a single wire going to it. Has a single small stud sticking out on top of it for wire clip.

Where is amp for a 86 vette located?

I assume you asking about the speaker amps. There is one in each speaker box. One in each door and one on each side in the rear.

A cheap way to add hp to 1978 corvette 350?

GM already implemented all the CHEAP ways to increase HP. You'll need to spend some money on high performance heads, racing cam, supercharger...

Why does my 89 corvette run great when she is cold and runs ruff after it warms up and there is no check engine lite on?

hey, Ive had the same problem with my 89 vette.This is what I did.Run the car till it warms up and then cut it off.Check fuel pressure with gauge.Gauge screws in on shrader valve on fuel rail.Turn switch on but do not start.Fuel pressure should be around 41 pounds.Turn switch off.Pressure should hold for several minutes at that pressure.If it starts to drop almost immediately like mine your injectors are leaking.The 89 came with multec injectors and are not made to run with ethanol in the gas.I dont know where you live but just about every station around uses at least 10 percent ethonal. I replaced with bosch III rebuilt injectors and runs better tham it ever has.Hope this helps.Don

Gas sending unit 1977 cotvette?

in the gas tank. Have to drop the spare tire and the tank to get to it.

What is a hot top?

A hot top is somthing thant is not a turtle neck or long sleves a hot top to me is slevles top or a top with a very very low neck on it that is what i like to where that is what i where every day

How do you get the back hatch open on a 1984 corvette?

There is a switch on both the drivers side and passenger doors. It's inside the door...jam. It's not a jam really, but I can't think of a better way to explain it.

There is also a yellow button inside the center console.

Where is the fuel pump on a 1982 amc eagle?

On an American Motors Corporation Eagle, the fuel pump is located on the left side of the engine near the bottom because it is a mechanical fuel pump. It is run off the cam. You Should be able to find it by following the line off the carb that goes over the front of the engine. IF you do not have an AMC Eagle but a vehicle that has EFI system. Then the fuel pump will most likely be located in the gas tank. AMC Eagle owners needing Questions answered should go to "www.amceaglenest.com".
It is a helpful website made by AMC Eagle owners for AMC Eagle owners.

How to disable 1981 corvette security system?

Remove the fuse labled theft. It is in top lh corner

Can a fuel injested engine fit into a 1979 corvette?

sure it will fit, you will just need the computer and wiring from the donor car .

Remove outter door handle on 1976 corvette?

remove the door panel. there are 2 nuts that u can acess thru the door on top. 1 is easy to get out the other 1 u need a skinny hand to get to it. hope this helps

How do you take the rotors off Corvette?

you do not say the year if it is a C3 then you have to drill out the rivets which are put on by the factory i think there are 5 or 6 on each rotor

How do you remove the shift knob from a 1999 corvette manual transmission?

First remove the shift knob pattern (it can be pried out with a small screw driver). Next remove the alignment pin with a pair of pliers. Then the shift knob can be unscrewed.

Bore and stroke of stock 350 Chevy motor?

A 350 Cubic inch Chevrolet engine has a 4.00 inch bore with a 3.48 inch stroke to produce 349.67 cubic inches of displacement that is rounded up to 350 cubic inches.


I know it is splitting hairs, but the displacement is slightly more than (due to rounding errors): 4.00 (bore) * 3.48 (stroke) * 3.14159 (pi) * 8 (cylinders) = 349.84


This knowledge might be useful for a bar-bet at the local watering hole.

Location of Oil Pressure Sender 1980 Corvette?

its the valve just above the oil filter with one lead coming off of it

When my 1969 corvette with a 4 speed goes into gear into gear the car will not move and if I let the clutch out the engine stalls.?

locked up e-brakes? frozen calipers? locked tranny is unlikley, unless broke up inside. differential problems maybe?

What is the firing order 1973 Corvette with points ignition?

The firing order for a 1973 corvette 350ci and the optional 454 is 18436572 Firing order remains the same for breaker point ignition as well as HEI electronic Position of #1 plug wire on distributor cap changes slightly when converting to HEI from a standard breaker point ignition system...............sfvrider242

How do you replace the roof brake light bulb on a 1988 Corvette?

Open the hatch on your '88 corvette all the way. Underneth the roof brake light, inside the hatch there a couple of screws that need to be undone. Once you take these out, the entire compartment for the roof brake light will come away from the body/hatch. Then there are a couple of more screws at the bottom of the compartment that have to come out, by taking them out you will now gain access to the bul area. If my memory is correct, there is actually 3 or 4 small, but expensive bulbs inside there, anyone of which could be bad. I hope this helped.

How many 2004 corvette z06 made?

5,791

http://www.the-mcies-corvette.com/history%20c5%202004.htm

How much is a 1975 350 corvette w40000 miles worth?

depends on condition of the car, interior, exterior, crash history, number of owners, etc.

What is the L-82 in the Corvette?

The L82 was an engine option. The L82 had more horsepower and torque than a stock 350 or L48. There were various differences, including many internal parts and the heads.