Glue and Adhesives

100 % silicone, because it's both water and mildew proof.

Rub it with Goof Off on a rough rag, it will soon become soft enough to peel an edge.

cement

No, but you can buy heat shrink tubes at plumbing stores that have a glue coating inside the heatshrink. This makes your joint totally waterproof. It works very well and is actually intended for insulating the connection wires of deep well submersible pumps. It's sold as "Wiring PRO Heat Shrinkable wire splice kit."

There are now MANY kinds of Elmer's glues. However I will assume you are referring to the original, and this is mainly composed of polyvinyl acetate.

( Elmer recently introduced a new spray adhesive and Glue-All Max, which is a polyurethane, similar to Gorilla Glue. )

You should use a spray contact adhesive. 2-4 available in Home Depot.

If you sleep on it, it may start to change your desired style and look messy however it will keep the rock hard hold for atleast 2 days before it starts to rub off on your pillow. However if you didn't sleep I would say 3 days of nonstop hold

No, Rhino Glue is not currently (2014) sold in stores; only online. Rhino Glue is a commercial grade of glue that is said to bond to just about everything.

It can hurt you, cause it can bond your eyes and skin in seconds, so i would say yes, it can hurt you.

No, it's entirely chemical based.

The USPS still makes and sells water-activated (lick and stick) stamps in lower denominations such as 10-cents.

If you rub acetone on super or Krazy glues it will soften them enough that they can be peeled off, or will disappear entirely if a small piece. Acetone is a solvent for these glues.

I would have found it easier to phone Carter Lumber and ask THEM, than to enter this question and not even say where Carter Lumber is.

It would have helped a lot if you specified what exactly, rather than just 'glue' - there are many different kinds with different solvents. However, try Goof Off, that will soften many glues. Rub with a rag dipped in this and it may soften enough to peel off. Other wise, scraping with a piece of hardwood shaped like chisel may get it off too.

There are different types of 'cap' that are plastic and glued to the drainpipe. If this is under the kitchen sink, and is a 'p' trap, then the plastic nut either side of it will unscrew with a pair of channel lock pliers or a small pipe wrench. If, on the other hand this is a 'cleanout' cap on the end of a drainpipe, then there will be a 'nut' formed into the end of it. Turn this nut with a wrench to remove it. Have shallow bowl or small bucket ready to catch water from this.

If you put glitter glue on your hand it will go all red and sting, but if you swallow it nothing will happen.

I have seen it in many hobby stores, hardware stores and Walmart.

Surgical glue is now often used instead of conventional stitches. It leave no marks, as stitches or staples do.

I would recommend Mortar Glue. It's the number one slate glue that's out there. You can find it at your local hardware store. just kidding i don't know

A tile mastic such as Mapei Ecobond. See the tile aisle in Rona or Home Depot for this product.

No animals are in glue.

Use fingernail polish remover. Pour some in and let set, it will disolve it.

I presume you mean remove not clean?? why would you want to clean adhesive??

paint stripper will often work, depends on what that vendor used likely EVA

YES! In essence wood glue is a denser version of paper glue.....