0
GM and GMC
This category covers questions about General Motors and its second best-selling division, General Motors Company (GMC). General Motors currently has four main divisions in the United States: Buick, Cadillac, Chevrolet, and GMC. General Motors was founded in 1908 and employs over 200,000 people, with its headquarters being in Detroit, Michigan.
3,195 Questions
How do you replace a fuel pump on a 2002 GMC Seirra 2500 HD?
That would depend on whether it is gas or diesel. I can fax the instructions to you with the vin number of the truck.
98 blazer starts but wont stay running?
my guess woul be that your EGR valve is bad or is sticking i would pull it out and check its the thing under the inlet of your intake if its good then the valve on it will move back and forth easy if its bad then it will stick
What size engine is in a1954 gmc 630 fire truck?
1954 GMC General Fire Engine with a 630 Cab had a 503 cubic inch straight 6 cylinder gasoline engine.
Have 2000 gmc serria no heat when idle give it gas then heat?
First be sure the coolant level is not to low, if the level is okay check engine temp gauge, it should reach normal operating temp (aprox 200 degrees F). If not replace the thermostat. If it does reach normal operating temp feel both heater hoses with your hands. They should both be almost the same temp (hot). If one is hot and the other is warm or cold flush the heater core, it is plugged.
ok well in the summer i blew a heater hose because i put a lift kit in and didn't lenghten the heater house but anyways it broke the plastic piece that rubber hose goes on so i never put the plastic peice back on just by passed it would it be because there is no restricker in there to slow down the coolant would that do it...if not i'lll check the hose's t.m to see what i find...thanks
Where is fuel pump relay on 1998 GMC 1500 truck?
Type your answer here... fuse box under hood drivers side
Coolant leak on the firewall at the passenger side?
remove hoses from firewall and make sure there is no rust or buildup on tubes. reinstall hoses and make sure hose clamps are really tight. If this doesn't work, your heater core needs to be replaced.
How do you adjust the linkage on cable from steering column to transmission on 1995 GMC van?
I believe it is adjustable from under the van. At the place where the bracket mounts to the tranny.
Why does your 1994 gmc four wheel drive not lock in?
Need more specifics on this question. What isn't locking in? does the transfer case lock in? Do you have aftermarket hubs? Sometimes you need to make a full tire rotation backwards for the hubs to lock. The hubs could be broken inside.
Why doesn't the auaillary brake light and alarm go out on my 1992 GMC topkick?
May be low on break fluid or the light switch might not be working or their is alot of resistance in the fluid level switch.
Why does a 1987 gmc 2500 run for ten minutes then flood out?
Coolant is being sucked into air intake manifold and entering cylinders. Bad intake manifold gaskets (assuming all vacuum lines are correctly routed).
Can you impression a GM sidebar door lock?
If the lock is 6 cut or 10 cut, either way yes it can. it takes alot of patience and practice
for 6 cut use light turn pressure, and it will mark on the side with the wide grove in it. the marks are really faint and you may need a magnifying glass to see them.
theres videos on it
Where to find a fuel pump fuse on a 1999 gmc truck?
where i the fuse for a fuel pump on 1991 gmc truck
What size windshield wiper blades do you need for a 1989 GMC G-Series Vandura?
The 1989 GMC G-Series Vandura takes 16" replacement windshield wiper blades on both sides front.
Where is the fuel filter on 1995 GMC pickup?
Inside the frame rail, driver's side, almost even with the door.
Will 1985 Chevy truck front clip fit a 1980 GMC truck?
Yes, they will bolt up. If I remember correctly, from 73-87 was pretty much the same truck.
Is the rear main seal in a 1994 Chevy 350 a 1 PC or 2 PC?
That would be a 1 piece solid round rear main seal.
No need to remove oil pan on that deal. You must either pull the engine are transmission to replace the seal. One are the other your choice. That seal slides over the back of the crankshaft, And it will pop right out no problem. Just alot of work to get to it.
Where is the fuel pump on a 1993 GMC truck?
Pull the bed off then disconnect fuel lines and then take off fuel pump locking ring and it shud come rite out,
What is a 1952 Frigidaire Wonder Oven made by General Motors that still works worth?
What is a 1950 custom imperial oven made by General Motors, that works worth
Thank you!
Drain the cooling system.
- Remove the radiator.
- Recover the refrigerant.
- Remove the receiver dryer.
- Remove the condenser inlet hose bolt.
- Remove the condenser inlet hose.
- Remove the condenser outlet hose bolt.
- Remove the condenser outlet hose.
- Remove the condenser from mounts on the radiator.
- Remove the condenser...........................
One group of French settlers in Canada called their region Akadie, from a native American word. they were called Akadians, and when they were exiled and emigrated to Louisiana, the spelling was changed to Acadia
