Which fuse for Hyundai matrix central locking?
The fuse for the central locking mechanism can be located by looking at the diagram on the inside cover of the fuse box. The fuse box is located in the engine compartment.
What do the warning light on a Hyundai coupe y reg mean?
When there is a component on the engine that is malfunctioning the warning light will turn on. The code should be assessed for what needs to be replaced so the light can the be reset.
Your 97 Hyundai tibouron wont startbattery is goodbut car wont crank?
If a 1997 Hyundai Tiburon will not start and the battery is good, the reason why it will not crank or turn over could be the starter. It could also be that the timing belt is broken. The motor could have also seized up due to a piston breaking. Also check the fan belt.
What is Hyundai target market?
Hyundai's target is market started had focused toward the lower income bracket, released compact cars under price points of its competitors. Having grown as a company since this Hyundai focuses on middle income brackets centralized around their mid-sized sedans.
How do you remove the rear seat in a Hyundai XG350L 2002 to get to the struts?
The rear seat on a 2002 Hyundai has bolt behind the seats. Push the seat down to reveal the bolts, and loosen them. The seat will be able to be removed from the vehicle.
Is a Hyundai vehicle a good investment?
Yes, a Hyundai vehicle is a good investment. The vehicles tend to hold their value well and get excellent gas mileage.
How do I know when I need to replace the water pump in a 97 Hyundai?
The water pump circulates the coolant throughout the engine. When a pump fails on a 1997 Hyundai the coolant will not circulate properly and cause the engine to overheat.
How do you replace an interior door handle on a Hyundai?
The interior door handle on a Hyundai latches onto the locking mechanism of the door. First remove the old handle by unscrewing it from the door panel. Pull the handle out and remove the locking wire. Install the new unit with the locking mechanism in place. Tighten the mounting screw.
How do you open hood of a 2003 Hyundai with a broken cable there is no opening in the grill?
To open a jammed hood on a 2003 Hyundai raise the vehicle's front end. Safely stabilize it and take a flashlight under the car to locate the latch. Use a flat head screwdriver to manipulate the latch and open it.
How do you enter code for Hyundai radio?
The preset buttons on a Hyundai will also act as dials to properly scroll through the appropriate numbers. To enter into the code mode press and hold down the 'band' button for 3 seconds.
On a 2002 Hyundai xg350l where is the tcs and tcm located the lights keeps coming on?
On your left next to the cruise button
Where is the fuse for radio on Hyundai coupe 98 model?
The fuse for the radio on a 1998 Hyundai is found in the cabin fuse box. The fuse is found in slot 13.
Hyundai's target market is those who are low on cash, would like all the accessories (auto windows, sunroofs etc...) but don't necessarily care all that much about the over all comfort of the car. All the Hyundai's that I have driven, although they have many accessories, are not comfortable and have very bad sound suppression. Think college students and people on low or fixed incomes that don't want a beater.
They also work very well as town cars, not commuters.
What causes the reverse lights to stay on all the time on my 1999 Hyundai?
pretty vague, could be worn linkage in your gear box that pushes the switch.
How do you replace a Hyundai Starter?
Depending the which Hyundai the starter will have to be reach from either underneath the vehicle or above. First disconnect the battery and remove the starter mount bolts. Disconnect the solenoid and remove the old unit. Replace with a new part.
Why Hyundai will crank but not start after it is hot?
I think I understand the question. If you are talking about it not starting after you have drove the car and it is hot. If that's the case, it probably means the timing is off.
How do you remove the dash of a Hyundai lantra?
The dash on a Hyundai Elantra is held on by several mounting screws. Remove all the screws found underneath plastic covers, as well as underneath the dash. Gently pull the dashboard towards the cabin and remove any attached sensors.
How do you flush transmission fluid on 2002 Hyundai?
The transmission on a 2002 Hyundai will have a drain bolt located underneath it. Loosen the bolt and drain the old fluid into a pan. Once done use Hyundai recommended transmission fluid and pour it in.
Why my Hyundai won't start when ignition is on to start?
I have an 02 Santa Fe 2.7 engine. Car died out in the middle of traffic w/ no warning, no noise just stopped. As it turns out when my husband disconected the battery after 5 mins. it erased all the engine codes & it won't give them to u again till the car starts & u drive it for 30 mins. for it reset codes..... Well our Santa Fe wouldn't start... so we had to go at this blind sighted. After 2 weeks of research on the net I found out that something finally gave in the car & engine set itself to defult code & it actually died like that because it's a safety feature & the car shuts itself down.... no fuel no spark so ensure no further damage of engine. I checked the battery & cables, fuses, relays & 2 weeks b4 this I had just done a tune up changing the plugs, wires & oil & filter. So then (after research) we changed the crank shift sensor & boy was that bad.... exposed wires touching each other. The fuel cut off switch turned back on at this point. For sure that had to b it..... nope she would crank but still not start. Then we changed the camshaft sensor..... put the car together.....nope. Still wouldn't start. Found out that a faulty air mass flow sensor would make the car not start too if it wore out completely. So we unplugged that sensor because other sites said it was safe to do this. If car started then we new we needed a new air mass flow sensor. No car still wouldn't engage. I was running out of things to look up. I was gettin upset because evertone elses story had a happy ending.... why did mine not wanna work? Then I saw a site that said if u have a faulty engine control module that u could test it by starting the car & bangin on the dash at the same time & c if that help it to make a connection. Though I don not recommend this heck I was runnin out of options..... (Keep in mind at this point it still could of been 1 or all 3 of the ignition coills) So I went back to the car to try & start it & bang on the dash at the same time....... I told myself well just for kicks I'll unplug the main relay.... the engine control module in the fuse box & check that out.... no, that's looks good..... then I checked the fuses for the engine control module (keep in mind I already did this in the begining) by darn the 10 A fuse for the engine control module was now shot..... So I took my horn fuse out & put that into it's spot & car starts right up now!!! WooHoo, finally I can tell a happy ending on here too.... I learned to much info to tell u all of it but if u check the ignition coil(s), cpk, maf, camshaft sensor, battery, battery cables, fuses, relays, ecu, fuel pump, fuel pump lines (check for cloggs).... that's about it...... But don't take my word for it I am only a house wife who found alot of info on the net & relayed that info to my husband.... I hope this info can help others to..... hopefully w/out so much research time. P.S. we didn't have any special tools to do any of this work...... so for any of the do it yourselfers.... it was actually more intimidating thinking .... it's a newer car can we fix it? But once my husband actually got under there it wasn't that bad at all. Time consuming & hard.... but do-able.... One more thing if u change the plugs & wires on ur Santa Fe & then the car go crazy w/ a mind of own engine reving..... that happens when u acidently pull one of the cable wires out of it's space.... u must put that back in place & I think tighten that back up..... It happened to us.... it was a 5 min fix..... can't remember just exactly what my husband did..... but if that happens it the cable was pulled out of groove or space & needs to go back...... Good Luck & Don't Give Up!
How do you remove radio from Hyundai Coupe?
1. Pop out cup holder in console. Remove the 2 screws that you can see inside. 2. Now you can pop off the entire console bezel. 3. Next remove glove box by popping out the 2 black clips on each side of the glove box. The glove box will now fold down out of the way. 4. Behind glove box remove heater wire control cable. 5. Now look under drivers side dash just above gas pedal. There are 2 more heating control cables that need to be unhooked. 6. Now the entire console bezel will pull forward. 7. Disconnect electrical cables from dash clock, hazard lights, defroster, AC and fan control. 8. The bezel will now completely come off. 9. Remove 4 screws holding radil