Lexus ES

The fuse box is located to the bottom lrft of the steering wheel behind the coin holder. all you do is open it up and the pull it towards you of the rear hinges.. It will snap right back into place.

If you're describing the idler pulley or the tensioner pulley, it's probably a bad bearing. Pulley bearing failure is common and relatively easy to repair. Remove tension from the serpentine belt then turn the pulley back and forth with your fingers. It should make no noticable noise and should turn smoothly. If you can hear any grinding noise or if the pulley feels like the bearing is grinding, replace it.

that may be a hard question because of after market oil coolers I would piur it in till its full

There is a timing belt on the Lexus ES300 2003.

The 2002 ES 300 has a timing belt. Replacement intervals for that belt is every 90,000 miles.

can 22 inch rims fit on a 94 lexus gs 300

The 2011 Lexus ES-350 has a drag coefficient of 0.28 Cd.

one is under the hood but that's obvious - the other is behind the ash/coin tray - just pull out the door

The O2 sensor is located on the exhaust pipe under the vehicle. There is one right under the truck below the passenger. The second one is in the rear of the vehicle, just follow the exhaust pipe is very easy to locate and you can actual replace them yourself if the nuts are not corroded. Good luck.

Get all your recall information at www.totalrecallinfo.com.

The fuel filter for a 2000 Lexus ES300 is in the engine compartment on the driver's side right by the firewall under the master cylinder (the container for the brake fluid).

Lexus es models from1992 to present do not have fold down seats just the center arm rest!

its possable its the rocker cover gasket leaking oil on to the engine, obvoiusly when hot it will burn it off and its most noticable when at a stop

The height of the 2008 Lexus ES-350 is 4 ft. 9.1 in. (57.1 in.).

The curb weight of the 2008 Lexus ES-350 is 3580 lbs..

The 2007 Lexus ES-350 is 5 ft. 11.7 in. (71.7 in.)10 -way power driver seat wide.

UNDER DASH BEHIND GLOVEBOX. TWO BOLTS TO REMOVE. MADE BY PIONEER.

Trouble code P0441 means: Evaporative Emission System Incorrect Purge Flow

According to the Gates website ( they make timing belts etcetera )

The 3.0 litre V6 engine in a 2003 Lexus ES300 has a timing BELT

how do you change spark plugs on 1995 Lexus es300

Apparently this is a fairly common problem with Neons. The speedometer is controlled electronically, so there is no mechanical cable. What a number of people have found is that the connection between the plug pin and the circuit board in the instrument cluster breaks down. One test to see if this is the problem is to press on the right hand side of the instrument cluster sometime when the speedometer is not working. If it works while you are pressing on the cluster, there's probably a connection problem at that point.

The solution: remove the top cover of the dash board (snap fit -- just pry it up) then remove the instrument cluster.

You'll have to take out 4 screws and the lower right is hard to get to.

The screws to remove are the phillips screws in the white tabs, top and bottom left and right; After that, however, slide the instrument cluster slightly toward the steering wheel to unplug it, and just lift it out. The four torx screws can easily be removed in your shop after you have taken the panel out.

If you try to remove the torx screws first you will drop the tool and have to remove all the lower panels to retrieve it. I wasted 3 hours doing that, before using the four philips screws, which took about 5 minutes.

There are two groups of connectors, one on the right the other on the left. The speedometer connection is one of those on the right. Take off the back of the instrument cluster and remove the circuit board (gently so you don't crack or break it).

Unplug the multi-connection ribbon. On the back side of the pins for those groups of connections, a small portion of the pin protrudes and is surrounded by a little bit of solder. What many have found to be successful is touching a hot soldering iron to those short pin extensions until the existing solder changes color all the way to the circuit board. (The change in color indicates it has melted.) Do not add any more solder, just reset the existing solder.

Which pin? Do all 20. If the pin for the speedometer is faulty, the others are probably not far behind.

Reassemble the instrument panel, plug it back in, and screw it home. The only difficulty in snapping the dashboard cover back in is getting the alignment pins toward the front of the cover to go into their holes. Sometimes the anti-rattle cushion on the front edge of the cover comes out of place and needs to be resecured.

Yes , it's a NON - interference engine according to the Gates website

They manufacture timing belts etcetera and recommend changing the timing

belt every 60,000 miles

The curb weight of the 2009 Lexus ES-350 is 3580 lbs..

Check and make sure the rack is not also leaking. I ended up replacing the entire system (everything that had power steering fluid run through it) in my 94. Also the power steering pump turned my fan - you run out of P/S fluid and your transmission burns up.

The Best: http://toy-lex.com/