get the Schley tool that holds the crank. use a good 1/2" breaker bar to hold the Schley and a 3/4" breaker bar with 22mm socket to loosen the nut

If it comes on it means the temperature of your engine is too hot. Your engine is overheating.

Every 90,000 miles

Depends. Light cycles on when traction control is activated due to road conditions causing rear wheels to slip. However, If check engine light is also on... there is a malfunction that can be located by checking ecu error codes.

to replace front rotors first remove two bolts that hold on the caliper. use a piece of wire to tie it to the upper strut do NOT let it hang! then remove two bolts that hold on the caliper tray i think they are 17 mm you will need a breaker bar to do this. then take off the rotor sometimes they are rusted so have some penetrating oil and a hammer or rubber mallet to smack them loose.

5.7 qts with filter, look in your manual. I was shocked to find this out and made sure the mechanic I use was aware, he went to LEXUS web site and found same answer.

The 2000 Lexus GS300 wiper blade sizes are 24" drivers and 20" passenger side wiper blades. See Sources and Related Links below for more information. Since there are over 22 different wiper arm attachments, do not buy wipers just by length only. Be sure to lookup exact wiper blade part numbers by vehicle make, model and year for the brand wiper you decide to purchase. This ensures correct length AND correct attachment.

i have a 2001 gs300 and got a estimate of $1,000.00 from a local repair shop--being handy i researched buying one on line for about $300.00 ang replaced it myself--the biggest problem was cutting the flange bolts connecting the conveerter to the extention exhaust pipe

why they is considerable organizational resistance to the introduction of information system

The air filter is inside the black box behind the battery on the driver's side of the engine bay. There are two 10 millimeter bolts on the airbox that hold it closed.

Yes, you can put 20 inch rims on a 2006 Lexus GS 300 as long as the rims have the same bolt pattern as your existing rims. You should be aware though that putting bigger rims and tires on your vehicle can affect the gas mileage.

Probably because it has quite low torque when compared to its weight

I am sorry to be the bearer of bad news but to replace the starter you must remove the intake manifold since the starter is underneath the manifold. You had better know what you are doing for this job. I think it costs between $800 and $1500 to get this done. vbd

If I m thinking correctly what you are referring to is the 100A fuse in the engine compartment fuse box next to the battery. You do need to remove the battery to get access to the fuse which attached with nut and bolt on its terminals.

1. Get chains or cables

2. Start in 1st gear then switch to 2nd and Drive as you get going faster.

My GS400 has a snow button. This basically reduces the power to the rear

wheels at low speeds but does nothing at normal speeds.

My wifes gs300 1993 window fell off the regulator. I am trying to get the panel off. I have found three screws along the bottom edge. One screw under a square cover near where you grab the door to close it. One screw in the duct that passes air to the vent on the door. There are some clips that pop out but the top of the door is still firmly attached. I can not conclude if the panel on the top detaches first. I have poped it loose a little but I probably broke some parts, at this time would not recommed trying to sepearte the top part of the panel from the lower. Hope to find out more. ed spam1@pobox.com

No, rims from a 1998 Toyota Camry will not fit on a Lexus GS 300. Rims are not interchangeable from a Toyota to a Lexus at all.