Lexus IS

You have to remove the wheel well lining to have access.

The 2008 Lexus IS-250 has a 2.5 L base engine size.

The 2012 Lexus IS-250 has rear wheel drive.

in the trunk passenger side. lift the black cover to the indentation an you will see the factory amp.

YES. Lexus recommends this changed at 90K miles

it is located between the radiator hose going into the water-pump housing.

Weighing in at 1580kg, the Lexus IS300 was released in 2005 with six cylinders and a rear wheel drive. It also has a power of 213 PS at 5800 rpm and an automatic five gear with sequential mode.

The 2006 Lexus IS-350's engine produces 306 hp @ 6400 rpm.

The front track of the 2010 Lexus IS-250 is 5 ft. 0.4 in. (60.4 in.).

you cant... unless you remove the ground within the car in which case im no help

Very simple. After you have safely raised & supported the rear of your IS & removed the wheels, you will see a through-pin on the outer edge of the caliper. Remove the pins' retainer clip & pull the pin to the outside direction. This will free up the anti-rattle clip which is a single piece for both pads. Then simply pull the pads up & out of the caliper. There should be two anti-squeak shims behind each pad. Depending on the brand & quality of your replacement pads, you may need to clean & reuse those shims. I recommend you always purchase new shims & anti-rattle hardware. But if you're 'on the cheap' & they aren't broken, should be OK to clean & reuse. Use a small wire brush to clean out the area of the calipers where the pads sit in. You will also need to push both pistons back into their bores of the caliper to allow room for the new, thicker pads. A large flat screwdriver will accomplish this easily. It may be easier to loosen the master cylinder cap to allow to fluid to more quickly flow back into the cylinder.

Assembly is the opposite of what you've just done. Pretty simple really. No need to remove or unbolt the caliper on this design.

That depends on if you want the 2012 model or the 2013 model. The 2012 model would set you back $40,220. The 2013 model, is pricier by a hundred dollars, costs $40,320.

The 2008 Lexus IS-250 is 15 ft. 0.1 in. (180.1 in.) long.

The curb weight of the 2011 Lexus IS-250 is 3455 lbs..

if you have 4 of them all at the same height, I would guess they are actually your rear reversing sensors. Cover them and you will get a continual beeping when you reverse.

4000thz

You normally change the oil on anycar every 2500-3000 miles. If there were a special condition it would be stated in the manual.

You can easily drive 5,000 miles between changes on modern engines with todays oil and filters. The 3,000 mile oil change is only recommended by people wanting to make money off it. Read your owner's manual and see when they say to change it. Probably around 7,000 miles.

The gross weight of the 2010 Lexus IS-350 is 4500 lbs..

The 2014 Lexus IS-250 has a V6 engine.

18 city

22 hwy

They are luxury vehicles.

The 2008 Lexus IS-250 has 24 valves.

You can use a brush paint kit or a spray pint kit. Most kits say you don't need to remove the calliper, but it's much better if you do, to avoid any contamination of braking surfaces. The majority of professionals would spray, as it provides a better finish most often, however, if you are good with a brush, and you take your time, you can do a good job. When spraying, try and hang the calliper up if you can, it will make your life much easier and provide a better finish.

The gas tank on the 2012 Lexus IS-350 holds 17.2 gal..

The ground clearance of the 2011 Lexus IS-250 is 0 ft. 5.7 in. (5.7 in.).