Machinery and Tools

Depends on the manufacturer and the quality of the tool. Lower end tools will use chrome vanadium. Higher end tools will use some form of tool steel.

A box wrench has that feature.

A long handled wrench gives you more leverage on those very tough bolts. However, a long wrench also has difficulty moving in tight quarters, so to counter this I carry a 16" piece of 1 1/2 steel pipe, flattened at one half. This easily slides over even my biggest wrenches giving me a lot more leverage, yet being able to shorten if I wish.

You can, but an oil based cleaner would be better. I use WD40.

As long as it fits the arbor, yes.

Usually by the length and thickness of the main shaft.

A wrench has no freezing point, and anyway your hands will freeze long before any wrench is even affected.

A mitre saw can cut wood at any angle you wish in both directions.

That's correct. This particular wrench holds the nut or bolt head better than any other wrench.

You could try but it is not advised. Jumping rope would put a lot of pressure on the knee and would probably make your injury worse.

No, you not need a licence.

It's a steel shaft about 1/4 inch diameter, 6-8 inch long, with a flattened and squared off end and a wood or plastic handle at the other end.

A drill press is a large drilling machine that stands on a very heavy steel base. A 3" or 4" steel column extends up either about 6 feet for a floor model or 3 for a bench model. At the top of this column is an elongated box with the motor at the back, driving a shaft with a 4 tier pulley above it. The front of the box contains a hollow shaft with a spindle inside it and a drill chuck on the lower end. In the middle of the column, a steel table, usually about 15 " square can move up and down the column to adjust work height.

A hacksaw is a metal frame that holds an adjustable and disposable blade for cutting metals. Blades are usually 12" long and 1/2 wide with a range of teeth for cutting different metals.

A basin wrench is a tool to remove and replace the nuts that hold a faucet in place. It works in tight, low visibility places for sink repair. The basin wrench looks like a long steel bar with a claw on one end. This claw is usually spring loaded to keep a tight grip of the nut being turned, and can 'flip' to enable turning either way easily. The other end makes a "T" as a smaller bar goes across it.

Chisels are almost always a static hand tool, or a pneumatic one. I suppose electric is possible, but haven't seen one yet.

To cut wood with the grain.

In your inventory pull the rope to the life buoy. They will combine.

Is there a standard ? - I have screwdrivers in 5 flat sizes ranging from 0.75 mm x 2mm wide, up to 2.5 x 18mm.

To measure Angles, Process of Measuring Horizontal and vertical Angles

Pull.

I'm struggling to upload the pdf format for you.

You can look it up at hilti.com or contact your nearest Hilti Centre for the info you are looking for

Hope it helps...

off set