0
Nissan Stanza
The Nissan Stanza was launched by Nissan in 1973, and was then separated into twin models – the A10 Nissan Auster and Nissan Violet – in 1977. All the three cars were manufactured in Hiratsuka and Oppama in Japan.
394 Questions
How do I bypass the daytime running lights on a Nissan Stanza xe?
To bypass the daytime running lights (DRLs) on a Nissan Stanza XE, you can locate the DRL relay in the fuse box and remove it. Alternatively, you can disconnect the wiring harness connected to the DRL module. However, keep in mind that modifying your vehicle's lighting system may violate local regulations and affect safety, so proceed with caution. Always consult your vehicle's manual or a professional mechanic for guidance.
Where is the oil drain plug located on 1991 Nissan Stanza?
On a 1991 Nissan Stanza, the oil drain plug is located at the bottom of the engine oil pan. To access it, you'll need to look underneath the vehicle, typically near the center or toward the back of the oil pan. The drain plug is usually a hex or bolt-type fitting that can be removed to drain the engine oil. Always ensure the vehicle is securely lifted and supported before attempting to access the drain plug.
Where is voltage regulator on 1987 Nissan Stanza Wagon?
In the 1987 Nissan Stanza Wagon, the voltage regulator is typically integrated into the alternator. To access it, you will need to remove the alternator from the engine bay. Look for the rectangular component attached to the back of the alternator, which is the voltage regulator. If you need to replace it, ensure the alternator is properly disassembled according to service manual guidelines.
The issue you're experiencing with your 91 Stanza could be related to a problem with the fuel system, such as a clogged fuel filter or failing fuel pump, which affects the engine's ability to maintain power at higher speeds. It could also be linked to ignition system faults, like worn spark plugs or a malfunctioning ignition coil, causing misfires under load. Additionally, the transmission may be slipping or experiencing issues that only reset when the engine is turned off and restarted. A thorough diagnostic check is recommended to pinpoint the exact cause.
How do you change spark plugs and distributor cap in 1991 Nissan Stanza?
To change the spark plugs in a 1991 Nissan Stanza, first, remove the ignition wires from the spark plugs, noting their order. Use a spark plug socket to unscrew the old plugs and replace them with new ones, ensuring they are gapped correctly. For the distributor cap, locate it on the engine, then disconnect the wires and unscrew the cap. Replace it with a new cap, ensuring that the wires are reconnected in the correct order.
