Pontiac Vibe

To replace the cabin air filter on a 2004 Pontiac Vibe, first, locate the filter access panel, which is usually found behind the glove compartment. Open the glove compartment and remove any contents, then gently squeeze the sides to detach it and lower it. Remove the old filter by sliding it out, and install the new filter in the same orientation. Finally, reassemble the glove compartment and ensure everything is securely in place.

To temporarily disable the dome lights on a 2005 Pontiac Vibe, you can locate the dome light switch, usually found near the overhead console or on the light fixture itself. Set the switch to the "Off" position. Additionally, you can check the vehicle's door switches; if a door is ajar, closing it should also turn off the dome lights. For a more extended disable, consider removing the fuse for the interior lights from the fuse box.

To change the license plate lights on a 2006 Pontiac Vibe, start by opening the rear hatch to access the light assembly. Use a flathead screwdriver to gently pry off the light cover from the back of the assembly. Remove the old bulb by twisting it counterclockwise, then replace it with a new bulb and reassemble the cover. Finally, test the new lights to ensure they function properly.

The 2004 Pontiac Vibe typically uses NGK part number 7092 or AC Delco part number 41-101. These are iridium spark plugs designed for optimal performance and longevity. It’s important to check the owner’s manual or consult a professional to ensure compatibility with your specific engine variant.

To change the oil filter on a Pontiac Vibe with a 1.8L engine, first ensure the engine is cool and then lift the vehicle using jack stands for safety. Locate the oil filter, which is typically near the oil pan on the underside of the engine. Use an oil filter wrench to loosen and remove the old filter, applying a bit of oil to the rubber gasket of the new filter before installing it. Finally, tighten the new filter by hand, lower the vehicle, and check the oil level before starting the engine.

To replace the Fuel Tank Pressure Sensor on a 2003 Pontiac Vibe, first, ensure the vehicle is parked on a level surface and the ignition is off. Disconnect the negative battery cable to prevent any electrical issues. Access the sensor, which is typically located on the fuel tank or near the fuel pump assembly, by removing any necessary covers or components. Carefully disconnect the electrical connector, unscrew the sensor, and then install the new sensor by reversing the process, ensuring all connections are secure before reconnecting the battery.

You can find an air conditioner compressor and clutch for a 2003 Pontiac Vibe at automotive parts retailers like AutoZone, O'Reilly Auto Parts, or Advance Auto Parts. Online platforms such as RockAuto, Amazon, or eBay also offer a variety of options. Additionally, checking with local salvage yards can provide used parts at a lower cost. Always ensure the parts are compatible with your vehicle model before purchasing.

To change the fog lamp assembly in a Pontiac Vibe, first, ensure the vehicle is turned off and the key is removed. Remove the screws or clips securing the fog lamp cover, then gently pull it away from the bumper. Disconnect the electrical connector from the fog lamp and remove the assembly by unscrewing or unclipping it. Install the new fog lamp by reversing the process, ensuring everything is securely fastened and connected.

To replace the O2 sensor in a 2003 Pontiac Vibe, first, ensure the engine is cool and disconnect the battery for safety. Locate the O2 sensor, which is typically found on the exhaust manifold or downstream in the exhaust system. Use an O2 sensor socket or a wrench to unscrew the old sensor, then install the new sensor by threading it in and tightening it securely. Finally, reconnect the battery and check for any error codes with an OBD-II scanner to ensure proper installation.