answersLogoWhite

0


Best Answer

Sounds like a bad starter solenoid

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 1998 k1500 turn key on dash lights up starter does nothingcan start with screwdriver under truck?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the solenoid located in Chevy k1500?

It is mounted on the top of the starter.


Position of knock sensor on 1990 GMC Sierra K1500?

It is screewed in the engine block over by the starter.


How do you change a starter on a 1997 Chevy k1500 4x4?

disconnect negative battery cable, remove the two bolts that hold the starter, hold starter up and disconnect wires remove starter and install new starter reconnect negative battery cable


How do you turn off chimes on a 1998 Chevrolet K1500?

There is a chime module but if it is disconnected may also affect the interior lights.


Where is the knock sensor on a 1991 Chevy k1500?

It is located right above the starter for a 5.7l V8, not sure for the 4.3 or 5.0, probably the same place


How come my parking lights don't work on my 1990 Chevy k1500?

You may have a blown fuse or a wire loose. Check these things to see if that is the problem.


Will a 95 k1500 Chevy trans interchange with a 91 k1500?

NO.


What transfer case does your 95 Chevy k1500 have?

will a 95 chevy k1500 transfer case hook up to a 96 chevy k1500 transmission


What tools do you need to remove the starter from a 1989 Chevy K1500 Pick up?

Your basic combination wrench set and 3/8" drive socket set should get the job done.


Where is the knock sensor on 95 k1500 blazer?

It is screewed into the passenger side of the engine block just in front of the starter. Thanks that what I thought. Actually I meant 1993 instead of 1995 but its the same place.


Is the transmission the same in a 97 Chevy k1500 5.7 as a 97 Chevy k1500 5.0?

YES. They are the same.


Where is the slave cylinder located on a 1998 Chevy K1500 6 cylinder?

Under passenger side of truck right below the starter. The slave cylinder for the clutch is in the Transmission Bell housing. You have to remove Transmission to repair it.