Yes! If you use some plastic mesh. Just follow the directions.
GAS.Answer:It depends on what kind of hole. In a body panel, you might use bondo, fibreglass, or sheet metal. You'll have to ask a more specific question for a more specefic answer.
The only fix not involving removing the door panel is to use plastic and tape to fill the hole.The only fix not involving removing the door panel is to use plastic and tape to fill the hole.
Yes, so you fill it up to the fill hole then screw the plug back in.
Simply fill thru the fill hole until fluid starts to run back out of the fill hole, reinstall plug bolt and you're done
Yes, you can fill in a hole, you can not fill out a hole
fill it until it starts coming back out of the fill hole
yes, it will fill the hole in the panel if you have no blank covers, if you want to be sure it is completely inert, disconnect the power lead and cap it.
take out the plug and fill it till it comes back out the fill hole
the hole dash panel.
Fill it till it runs out of the fill hole. Again that's the FILL HOLE, not the DRAIN HOLE. They are separate.
there is a rubber plug on the top portion of the motor .remove the plug,fill and put plug back on
The fill hole is the dipstick hole itself. You usually need a long funnel to get fluid into it, and it's slow to fill because of this.