0
Check fuse Check bulbs--they are double filamented with the smaller for turn signals Replace turn signal flasher--Most common problem
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Turn signals dont work but flashers do on your 97 expedition?
its either the flasher or the turn signal switch
Why dont your blinkers work in your 1990 jetta you changed the flasher and the fuses are not broken The hazards work but turn signals wont?
The 1990 VW Jetta turn signals will not work when the ground wire is broken or corroded. The turn signals may need the lightbulb's replaced.
My hazards work but turn signals dont in a 1987 acura integra checked the fuses and the relay but still not working?
It could be the turn signal bulbs, some vehicles use separate bulbs for the hazard and turn signals. It could also be a bad switch or wires for the turn signals.
How do you fix turn signals on a 1994 Cevy Corsica the hazard signals work but turn signals dont replaced bulbs fuses switch on wheel both switches uder dash no reponse nothing at all help please?
I had the same problem, after tearing apart my steering wheel to replace the actual turn signal switch, it turned out to be the flasher. which is located under the dash by the steering wheel. TRY THE FLASHER BEFORE REPLACING THE SWITCH. as a side note, be extremely careful not to pull the steering wheel cover out too far or the gear on the ignition switch will slip off, this took me an hour and a half to get back on properly.
You have a 1991 honda accord and the tail lights dash lights turn signals and low beams dont work you have replaced the fuses the lighting relay and the headlight switch nothing has worked can you hel?
CHECK FUSABLE LINKS AND THE IGNITION SWITCH.FOR 12VOLT REF
1994 cavalier--changed switch bulbs fuses hazards work but turn signals still dont work any suggestions?
have you tried replacing the flasher u need to replace the flasher can for the turn signals there are 2 one for hazards and one for turn signals usually found in the fuse box, and cost about 3 bucks
Where is the brake switch for 1996 Chevy Lumina?
turn signals work butt the brake lights dont can anyone help please? cant afford a mechanic.
Your turn signals dont work 4 way flasher works put new switch in still not working?
Check the fuse, and the Turn Signal Flasher Relay. The hazzard lights have a separate relay.
My park lights and turn signals work but your brake kights dont why is this?
it could be that your brake light switch under your dash that sits right on top of your brake pedal has gone out
Why dont your turn signals and emergency signals work?
If the turn signals and emergency signals don't workout sounds like an electrical problem's would suggest that you take it into the closest shop to get the problem diagnosed properly.
Gmc jimmy - turn signals dont work - hazards work - replaced fuse and ts flasher - signals still dont work?
Well - it could be the turn signal unit in the steering column - if its a high mileage vehicle it may just be worn out. you have to remove the steering wheel and replace the unit - the part on a GMC is about $30 +/-. This may fix the problem.
You have replaced all of the bulbs and flasher on your 1991 isuzu pickup yet all 4 turn signals dont work you can hear the flasher workink but the dsh indicators dont work and niether do the turn sign?
You need to pull the steering wheel and clean the contacts at the turn signal lever itself. Reference the manual for pulling the steering wheel and then be carful not to lose any of the small parts in the signal switch. Should take about 20 minutes to fix.
