If you get under your car, look between the transmission oil pan and the motor. It is in the rear of the block of your motor. If you have the tools it won't be difficult just dont do it when the motor is hot.
how to replace the crankshaft position sensor located in a 2003 kia rio
Crank position sensor is located next to the crankshaft. In order to replace it you might have to remove the timing belt. In the most models you just can remove remove the timing belt cover and replace the sensor.
1983 doesnt have a crankshaft position sensor. you have an ignition module located on the side of the distributor.
It is located behind the starter. You'll need to remove the starter to replace it.
Check out the related link for a video on how to replace a crankshaft position on a Ford Focus SE.
This would be located right behind the crankshaft. For the best assistance, you can use the users manual to get it fixed.
where is the crank shaft pistion sensor located on a 2002 Chevy Malibu, and how hard is it to replace
It is located behind the crankshaft harmonic balancer pulley on the bottom front of the engine. The right lower splash shield and harmonic balancer pulley must be removed to replace it.
Replace the crankshaft and camshaft senors and then clear the codes with an oBD II engine scanner and that will fix it.
if your fuel pressure is still good i would replace the crankshaft position sensor , it is located behind the crankshaft pulley, you will have to pull it with a puller.
if you are facing the engine it will be on the left upperside of the crank pully, on a target wheel. is it hard to remove and replace
at the back of the engine, below the throttle body, to replace, have to remove the intake manifold