answersLogoWhite

0


Best Answer

if you are facing the engine it will be on the left upperside of the crank pully, on a target wheel. is it hard to remove and replace

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the crankshaft position sensor located on a 1991 BMW 325I?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the crankshaft position sensor on your Honda civic 1991 located?

inside the distributor


Where is the Crankshaft Position sensor located on a 1991 Jeep Cherokee Limited?

Driver side of the bell housing.


Does a 1991 integra have a crankshaft speed fluctuation sensor?

There is a crankshaft position sensor that measures how fast it rotates


Where is the crankshaft position sensor on a 1991 Honda Accord?

In the distributor.


Where is the Crankshaft Position sensor located on a 1991 Jeep Cherokee Laredo?

paste this into your browser...i could not get the link box to take.. but this should ansewr the question on the o2 sensor


Where is the crankshaft sensor located on a 1991 dodge caravan 2.5L?

No crank sensor, only the sensor in the distributor.


Where is the crankshaft sensor located on a 1991 ford ranger 2.3?

Look by the balancer.


Why is a 1991 Chevrolet Lumina hard to start?

There are a few reasons. crankshaft position sensor, faulty fuel pump, fuel pump regulator, throttle position sensor, oxygen sensor. Need to have it diagnosed.


Where is crankshaft position sensor located on 1991 Pontiac 6000 LE?

Rear of the engine block (firewall side), below the center spark plug, just above the oil pan.


1991 jaguar xj6 cranks no fire out of coil?

The first place I would look would be the crankshaft position sensor


Where is the crank sensor in a 1991 Cutlass Supreme?

Behind the harmonic balancer (dampner) that is located behind the crankshaft pulley.


You would like to locate cam shaft sensor and crankshaft sensor for 1991 dodge caravan 3.0?

Crank sensor is in the top of the transmission housing at the back of the engine. Cam position sensor is in the distributor.