0
The brake sensor is built into the wheel bearing. The whole unit has to be replaced. It is best to replace both bearings. Left wheel and right wheel ---- 1998 models have the sensors as a separate component - See "Related Questions" below for more
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you replace the crankshaft positioning sensor on a 1989 ford sho Taurus?
To replace the crankshaft positioning sensor on a 1989 Ford Sho Taurus, go near the water pump at the front of the car and remove components that block access to the sensor. Remove the two bolts holding the sensor in place remove the wire that sends data. Finally, replace the crankshaft positioning sensor.
How do you replace a left front speed sensor cable of dodge ram 2004 1500?
The left front speed sensor is electric and does not have a cable. The sensor is accessed by removing the brake rotor.
How to repLace front brake pads on Mercedes Benz S430?
How to replace front brake pads on Mercedes s430
How do you change front brake pads on a 1996 Ford Taurus?
what tools are needed
What does it mean when the sensor light comes on in a 1987 Mercedes Benz 190E?
If you are talking about the brake sensors then it is time to replace the front brake pads. You should also check the rears while you are at it. When replacing the front brake pads you will also need to change the sensors also.
How do you replace front brake pads on 2002 mustang?
To replace front brake pads on a 2002 Ford Mustang safely raise and stabilize the vehicle. Remove the wheels and caliper. Slide out the front brake pads and replace with new units.
Do you have to replace the brake pads when you replace the front rotors?
no but it is recomended.
How do you stop front brake vibration on a 1997 ford escort?
replace front brake discs and pads.
How do you replace the front brake pads on a 1995 Jaguar XJS?
i am trying to replace front brake pads on 1995 jaguar xjs 2+2 is there a video on how to do this
Why is your front end squeeking and abs light on?
You didn't say what you were working on, But it sounds like you have a bad wheel bearing Assembly and the front axel is moveing around and has gotten into the brake sensor sometime are another. Check and replace wheel bearing and sensor as needed.
How do you reset brake wear warning message on 2009 c300 Benz?
Replace the brake sensor then the message will go away. When you saw the message the sensor is already bad so it need to be replaced along with the brake pads. You don't need to replace front and rear sensors at the same time. Any of them has the pads wearing too much (usually in the rear because Mercedes cars drive by the rear), that where the sensor need to be replaced. There is no electronic reset for brake pad wear message.
How do you repair front brake pads?
You do not repair them you replace them.
