0
After trying to bleed the clutch the clutch pedal will not spring back and you can't get it into gear Help?
Wiki User
∙ 8y ago
answer
pump pedal 1 2 3 4 to the floor hold,other person open screw on slave cylinder tssssit close screw then release pedal very slowly motion up,make sure reservoir wil not come empty,repeat repeat repeat in exercise motion verry well,until no more tssssit tssssit and it will be solid fluid ,gain
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
Why does the clutch pedal on a 1998 cavalier not spring back?
the return spring on the clutch pedal assembly must be replaced.
How do you bleed the clutch on an S-10?
pump the clutch pedal several times it should fix your problem
You have to pump your clutch pedal a few times for the clutch to engage on your Hyundai Excel 1997 how do you fix?
you need to bleed your clutch fluid
How do you bleed the clutch on a 95 Chevy Camaro?
Remove reservoir cap and pump the clutch pedal until air bubbles rise and pedal feels firm.
How do you install the clutch assist spring on the pedal for a 1993 Honda Accord?
How do you install a cluch pedal spring on a 93 honda accord
Mazda b2500 clutch bleed?
Just bleed at the slave cylinder. It so easy, it takes 5 or 6 pumps but does need two people. One on the clutch pedal and one on the bleed valve. The person on the clutch pedal pumps a few time whilst you have the bleed valve open. Ask them to push the pedal to floor and hold. Close the bleed valve and then ask them to release their foot of the pedal. Open the valve and ask them to repeat the procedure again When pure fluid comes out make sure their foot is hard down and close off the bleed valve. Full clutch pressure will now be available. Cheers Jim from Oz
What is the cause of a 97 elantra clutch pedal getting completely stuck?
You need to bleed your clutch master cylinder line.
How do you bleed a clutch on a 1993 Honda Civic?
Pump the pedal to the floor and then screw on the cylinder.
Clutch spring 240sx?
Adjustments is behind top of the clutch pedal. Clutch spring should be under the car on the transmission closest to the motor block, next to the slave cylinder.
The clutch pedal on your 89 240sx sticks to the floor it has a new clutch what do you do?
Bleed the slave cyl. It probebly has air in the line or no fluid.
How to adjust F350 Hydraulic Clutch?
Hyd clutch has no adjustment, pump clutch pedal hold down bleed off hydraulic slave cylinder on driver side of trans. If won't bleed replace if bleeds off no air in line & still not better ck bushings on clutch pedal under dash. Hope this helps
How is contact between drive and driven members of a clutch maintained?
clutch pedal over -centre spring pressure
