No
Yes it will bolt right up to it.
The fuel lines around the filter; you will need an adapter.
.043
Use an exhaust made for an LT1 engine the blocks are identical it is the insides that is different. Will bolt right on.
.43L. 1000ml=1L
It should be on the front of the intake manifold directly above and behind the water pump.
Don't know what year you have but some sensors are temperature sensitive and you should run a 195 degree thermostat.
4L60/E l
43L of 18-k gold
There is one before and one after the catalytic converter.
1993 CHEVROLET K1500 PICKUP V6 4.3 (262) Z GAS engine 4207 PLATINUM PART Gap=.035 4449 PLATINUM+4 Do not Gap HR9BP PLATINUM PLUG Gap=.035 4302 PLATINUM2 Do not Gap HR10BC SUPER PLUG Gap=.035 7585 SUPER PART Gap=.035
I have a '90 so I think it would be the same, on mine it is at the front of the engine on the bottom pulley. (crankshaft pulley or vibration dampener) To view the scale and mark I have to look down, a little on the drivers side of center. Beside the break resivour is a good viewpoint, looking just over the timing light. I have to run the timing pickup coil in through the drivers door or window and into the open doghouse cover. Good luck. God Bless!