0
Add your answer:
Earn +20 pts
Does a Chevy 305 mount to the same transmission as a 43L?
Yes it will bolt right up to it.
Where can you check fuel pressure on a 1990 V6 43L Chevy Siverado?
The fuel lines around the filter; you will need an adapter.
What is the timing for 1992 Chevy 1500 truck with 43L V6 with manual transmission?
0 degrees,should say right on the fan shroud on the same sticker that tells the spark plug gap. In order to time it correctly you must unhook the esc electronic spark control wire which is a tan wire with a black stripe located under the black cover on the passenger side firewall. It may set off a service engine soon light. When your done timing it unhook the battery cable and the light should go out.
How many kL are in 43L?
.043
How many liters in 43ml?
.43L. 1000ml=1L
Is there a thermostat 150 180 degree that will work in a Chevy S 10 V6 43L?
Don't know what year you have but some sensors are temperature sensitive and you should run a 195 degree thermostat.
Where is the exhaust gas recirculation valve EGR located on a 97 s10 Chevy blazer 43L AC v6?
It should be on the front of the intake manifold directly above and behind the water pump.
What transmission came in the 2002 43L s-10?
4L60/E l
How can you calculate the mass or the volume of 18-k gold?
43L of 18-k gold
Where is the Oxygen Sensor on a 90 Caprice V6 43L?
There is one before and one after the catalytic converter.
Are the spark plugs different on 95 chev caprice 43L V8 and 57L V8?
as far as i know the 4.3 is a v6 which is actually based off of the 5.7. gm just cut 2 cylindars off if there is a difference it will be the heat range on the plugs for your info, the Chevy 4.3 ltr in a 94-96 caprice is a 265 v-8, do some research before giving info on engines you know nothing about. oh and by the way, the power rating in a stock 4.3 v8 is higher than a stock 5.0 and also the correct answer is NO, the spark plugs are no different than the 305 or the 350.
Where is the EGR on a 1987 43L v6 Chevy Astrovan?
The EGR valve on your Astrovan is on the backside of the intake manifold just under the throttle body attached by two bolts. After installing a new gasket be sure and torque the BOLTS to 17-18ft lbs or the NUTS (if yours has studs) to 15ft lbs)
