What model is your vehicle? I have a repair manual for mine, it's a 1990 Lumina Euro, but the boks covers other models. I can check it and see where it is located, but it may not be the same as yours. Only if the engine is the same I'm guessing. I'll check my book tomorrow (05/19/06) and let you know what I find.
where is the crank positioning sensor on a 1996 newyorker van
above the starter
The crank positioning sensor is located on the opposite side of the block as the timing belt.
The crank shaft positioning sensor is behind the starter. A real bear to get to.
location of a crank shaft sensor on a nissan frontier 2002
2.0ltr its in distributer
no spark, no start
Can someone anyone please tell me where is the Crankshaft Positioning Sensor on a kia sorento 2005 and I also need a diagram
problably your crank positioning sensor, on the front of motor, behind crank pulley. about a $40.00 dollar part. good luck
They sell them at Autozone for about $160.00 www.autozone.com
in the front on side of the harmonic balancer
Here is the link where you can see how to install Crank shaft positioning sensor with detail pictures. http://dentnshell.com/Projects/2005Altima/CamkPosition.html
The only engine speed sensor is the pick up plate in the distributor.
the cam positioning sensor is located on the front of the engine block, above the harmonic balance pulley. easiest to get at this from underneath the vehicle,and to change the snsor, nothing else needs to be removed to get at it.
The crank sensor is located on the bottom of the timing cover under the right hand side of the water pump by the crankshaft pulley.
A 1986 ford van does not a crank shaft position sensor,, it uses the pickup in the distributer
It is in the oil pan. Nissan has had a recall to reprogram the sensor. They may have to replace the sensor for free. It cost about $600 for repair.
car will not start if the crank shaft positing sensor is bad ..because it control the car spark plug firing..( no fire no start )
No. It's just plug in and go.
Location of crank shaft position sensor of a Nissan altima 2.5 2004? send diagram please
The crank shaft positioning sensor should be located at the front of the engine just below and to the left of the harmonic balancer. On the timing cover.
Did John Brennen convert to Islam
98 Hyundai crankshaft positioning sensor location
The crank shaft sensor is on the bell housing of the trans, buy a new one and look for the plug end that looks alike. also if u are looking for the cam positioning sensor it is on the left side of the engine coming out of the valve cover.
No the ckf and the ckp are not the same sensor for a 2000 Honda civic. The crank fluctuation sensor is behind the crank pulley and can be changed fairly easy with some mechanical knowhow when the timing belt is done. The crank position sensor is built into the distributor. To change this sensor you would have to rebuild the inside of the distributor or replace the entire distributor. Hope this answers your question.