slave cylander for what?
slave cylander for what?
The hydraulic clutch slave cylinder is inside the manual transmission bellhousing
my clutch is not working ..think the slave cylinder is bad ..135 , 000 miles ..
The slave cylinder I think you are talking about is the clutch slave. The slave is mounted under the truck. It will be near the bell housing where it can push the clutch fork. Locate your clutch master cylinder and follow the line down to the slave.
Master Cylinder for brake and clutch are located next to the ABS unit on the firewall of the driver side in the engine bay. Slave cylinder for clutch is located on the bottom of the transmission.
In a 1988 Pontiac Grand Am you will find the clutch slave cylinder located on the flywheel. You will need to remove the hush panel from the driver's side foot well to gain access to the clutch slave cylinder.
there is no clutch cable. it has a hydraulic clutch. there will be a clutch master cylinder on the firewall near the brake M/C. a hydraulic hose will connect that to the clutch slave cylinder on or near the tranny. the slave cylinder pushes on a fork (lever) that disengages the clutch.
it is attached to the bell housing and makes contact with the clutch fork.
It has to be on the slave cylinder, not sure that was your question.
how to replace the slave cylinder on a 1993 jeep wrangler
Remember, keep the master cylinder full so you don't suck air into the slave cylinder. Then you put the fluid in the slave cylinder.
In cylinder
The slave cylinder for a hydraulic clutch is located inside the manual transmission bellhousing