Want this question answered?
Yes, just connect the heater hoses together.
Open the hood on your truck, look at the back firewall. You will see two water hoses sicking out. That is where your heater core is located. As for getting it out through the dash? Good luck.
No there is not. Whats the problem no heat ?? If so try this, reverse the heater hoses on the heater core and then go drive the truck and see if you get heat.
The heater box is under the dash.
With a release tool.
pull the dash out
1- Drain coolant. 2- remove heater hoses from core inlet and outlet pipes in engine compartment. 3-remove screws and heater core cover. ( right side lower passenger compartment ) 4- carefully lower core out of heater unit. This old of a truck it would be wise to replace both heater hoses. Use antifreeze as a lubricant to install heater hoses to new core inlets.
Drain the water from your Dodge Ram truck cooling system. Remove the water lines from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
you need the special tool its about 30 bucks from snap on
You don't have a heater control valve for this truck.......
duh.it is tottaly an dodge truck dosent matter what yerar as long its before and 2007 or below
Remove the water supply hoses from your 1992 Chevy S 10 pickup truck heater core. Remove the heater core retaining bolts. Reverse the process to install your new heater core.