Drain the water from your Dodge Ram truck cooling system. Remove the water lines from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
Drop the fuel tank
it could, all depends how off it is.
If its a gas engine yes, if its a diesel no.
The timing on a 1989 Dodge truck should be set to 10* after unplugging the temperature sensor.
bad alternator ? its not charging the battery
You have to get to it from inside the truck. It is behind the glove box but you can only get to it from under the dash. After you have located it you just unbolt it and then put the new one on.
inside frame rail under driver door
The easiest and quickest way to change the heater core in your 1988 GMC Jimmy is to remove the water from the cooling system. Remove the water lines from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
If you can find one that will bolt up, then yes.If you can find one that will bolt up, then yes.
Only for mounting
A "heater" or a "heater core"?
32 Gallons on a long bed extra cab with 5.9l
It's on the side of the motor
for someone who has never done it before,allow 1 week
Have you checked your suction lines.
Facing the front of the truck, it is located on the intake manifold on the right side of the carb.
The fuel pump relay on a 1988 Dodge Dakota truck is located in the engine compartment, near the fire wall. It is contained in a water tight box which houses a number of relays and fuses.
change the pickup coil in distr
Leaking head gasket ... return hose for the radiator ... heater hose, etc.
Is it a manual or automatic?
well i just recently did a heater core in a 1988 mustang gt 5.0 and i used aprox 5 tools (nothing special) and it took about 4 hours (including supper)
on top dead rotor should be pointing at #1