Depends on what you need to adjust. Air/fuel are on front of carb low on right and left, basic start point from seated is 3 turns out. The idle screw is located inside throttle linkage on right side. Fast idle is under choke coil on left(hard to get to). Secondary tensioner is located left upper,back corner. Allen set screw aimed down, loosten 1/2 - 3/4 turn and use sm. screwdriver on side- R+ L-.
If it is throtle body equipped, the idle control s solonoid controls it. If it has a carb there is an adjustment screw on the bottom of the carb.
kickdown cable. it connects to the linkage on the carb's throttle. as the throttle goes in the kickdown goes out.
check the carb...then adjust the valves...
No, thank you.
On top of your carb thers a cable that go in the carb just unscrew it and go frome ther to your lever On top of your carb thers a cable that go in the carb just unscrew it and go frome ther to your lever
Adjust carb on 400 Polaris 4x4 2stroke
"84 is still the carb. There is a small screw right at the throttle cable on the carb. Adjust that.
there is a screw on the carb. be sure to adjust while the engine is running so you can tell by the idle when it is set properly.
there is a set screw on the linkage on the carb that will adjust it.
it's the screw right above the mounting bolt on the left rear of the carb. you'll have to adjust the idle screw as well as you lean it out. then check your timing again
Adjust the throttle stop screw located on the side of the carb that has your throttle linkage connected to it.
adjustment screw is between throttlre linkage and carb body on the right side of the carb as you stand at the front of the car looking at the carb
twist the screw under the carb
with a screwdriver
Adjust or rebuild carb.
adjust the chock if it has carb.
It should be on the carb!