Remove doop panel, remove dust cover, remove two nuts holding window, unbolt guide post, unbolt motor, swing assembly thru openning
did you also replace the regulator? sometimes its the regulator that goes bad and not the motor.
It is inside the door, bolts to the regulator(the linkage that moves the glass up and down).
I AM GOING THROUGH THIS MYSELF. i HAVE LOCATED THE PART ON WWW.ROCKAUTO.COM (DORMAN PART # 74168) FOR 77.70 FOR THE MOTOR AND REGULATOR. i WILL POST MORE ONCE i REPLACE IT.
There could be several causes for this type of problem: 1) The power window up portion of the switch is not functioning or wiring is loose at the switch and or motor. 2) The motor is failing and is not providing enough force to raise the window or is off-track and inding. To check this condition lower the window , then grasp the window and when the up button is pressed assist it(leave enough space to ensure you do not pinch you hand.in the window frame) if the window motor operates and the window begins to rise the window could be binding or the motor replaced. in either case the door panel will need to be removed the electrical switch and motor are tested and the mechanical operator and track inspected for proper operation.
The question you ask is too involved for a proper answer. You may want to go to a car parts store, or book store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
Remove the window regulator and motor from the door as an assembly. Drill out rivets that hold motor to regulator and replace motor. Regulator needs to be riveted back into door for reassembly
Trade it in for a Holden
Remove the window regulator assembly from the door.Remove the motor from the regulator by drilling out the attaching rivets with a 3/16 in. drill bit.Connect the window motor to the regulator with 3/16 in. rivets.Install the window regulator assembly.
How to remove the window motor from the regulator
Window motor and regulator are found inside of the door panel and may be bolted or riveted in. Should be bolted. Disconnect the window from regulator, take out reg. and motor, then disconnect regulator from motor, reconnect new motor to regulator, reattach those inside of the door, then reconnect the window to the regulator, put it together and see if it works.
probably window regulator
window regulator cable is broken need new regulator
HOW DO I REPLACE WINDOW REGULATOR MOTOR ON PASSENGER SIDE WINDOW
You have to drill the rivets on the motor separating it from the regulator. The new motor then mounts to the regulator and you insert the new bolts where the riverts were.
You will have to replace the entire regulator assembly. The wire is not available.
remove your door panel there will be three screws holding it on. then you have to remove the screws holding your window to the regulator. then unbolt regulator and motor from door. Undo wiring going to motor.
if manual, window regulator. if electric, check fuses, window switch, window motor, window regulator.