answersLogoWhite
Auto Parts and Repairs
Serpentine Belts
Buick Rendezvous
Ford Escape XLT

How do you change a serpentine belt on a 2001 Ford Ranger 3.0 motor?

343536

Top Answer
User Avatar
Wiki User
2015-07-15 21:42:17
2015-07-15 21:42:17

you should have a tensioner assembly you can loosen up to get the belt off easier, and to slip the new one on. there should also be a schematic on the frame of your truck right where you lift the hood from. this will tell you the proper route to take with your new belt ;)

1

Related Questions

User Avatar

how do you change the serpentine belt on a 2001 Rodeo

User Avatar

I need to know if I need a special to to change my serpentine belt on a 2001 Buick Regal

User Avatar

how do i lossen the belt tensioner on a 2001 Hyundai Sante fe to replace the serpentine belt

User Avatar

Will anything happen to the motor if timing belt breaks on a 2001 ford ranger

User Avatar

hi this is peter i have a 2001 chevy blazer and how do i change the encoder motor on the transfer case? thanks

User Avatar

Look in your owner's manuel. It will help you out. And if it doesnt go to this web site: http://www.ehow.com/how_11_change-motor-oil.html This is a good helper.

User Avatar

I don't have the exact car model diagram but try this http://www.gti-vr6.net/library/engine/repl_serpentine_belt_NEW.html

User Avatar

How do you change oil on a 2001 sportster 1200

User Avatar

how do you replace a wiper motor in a 2000 jetta?

User Avatar

Whats the easiest way to change my serpentine belt on my 2003 Toyota celica gt.I need a diagram

User Avatar

where do you ad motor oil on a 2001 Kawasaki voyager 1200

User Avatar

Put the serpentine belt around the pulleys on your 2001 Chrysler LHS. Tighten the serpentine belt by pushing the tensioner pulley to the left. Tighten down the tensioner pulley and the serpentine belt will be tight.

User Avatar

whichhow to change the starter motor. ... 2006 Nissan Xterra

User Avatar

It is different for each engine size. There should be a sticker right under the hood near the hood latch showing all the patterns.

User Avatar

Remove the wiring harness from the back of your 2001 Chevrolet Corvette blower motor. Remove the blower motor retaining bolts. Remove the blower motor fan. Reverse the process to install the new blower motor.

User Avatar

www.helminc.com You can find a shop manual for a lot of vehicles.

User Avatar

Do u need to take the pulls off to change the water pump on a 2001 concordeLXI 3.2 motor

User Avatar

what are the correct steps to remove the serpentine belt that runs to the alternator on a 2001 Toyota AvalonWas that an ANSWER!? I assume the question is, "How do I remove and replace the serpentine belt on a 2001 Toyota Avalon". (You can remove it with a good sharp knife!)

User Avatar

how to replace water pump on 2001 ford ranger

User Avatar

With engine oil filter change ( 5.0 quarts / 4.7 liters of engine oil ) according to the 2001 Ford Ranger Owner Guide for the 4.0 liter V6 engine

User Avatar

The Best Ranger Challenge - 2001 was released on: USA: 12 October 2001

User Avatar

http://wiki.answers.com/Q/How_do_you_replace_a_blower_motor_resistor_in_a_2000_Grand_Am_GT


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.