Clutches and Flywheels
Ford Bronco
Ford Bronco II

How do you change clutch slave cylinder 1988 bronco 2?

User Avatar
Wiki User
January 20, 2008 10:56PM

wow i just did this on a 88 its fun anyway take out the rear drive shaft then transfer case then front drive shaft then unbolt starter then take out the trany to engine retaining bolts theres is 6 i think on the 5 speed 12 bolt. then work the tranny out of the clutch there are to screws on the slave cyc in side the bell housing in the tranny take the screws out lift the slave out and slide the new one in o ya the fluid hus on the side of the bell housing it a quik disconect push the whit cooler in ward and pull on the line have fun and good luck and buy a chiltons book