I had the same problem. I had to get tough with them. I know this doesnt sound right but you need to use a bigger hammer! Break it loose by hitting the hubs. working it side to side until it clears the inside drum. The pads are grooved into the drum and holding on the outside lip. Good luck!
it is a 1995 Chevy blazer and it will not go into park. have to use the emergency brake when stopped, and neutral to start it
you most likely need to change them
The 2004 Chevrolet blazer emergency brake is equipped with an adjustment bolt. Turn the adjustment bolt to loosen or tighten the emergency brake.
Rebuild the rear drums. Or maybe yank on the cable under the body.
The fuse or relay for power windows on a 2002 Chevy Blazer is located under the dash near the emergency brake. It can be readily replaced by pulling it out.
How do you adjust the emergency brake on your 2001 S10 Chevy?
The 2003 Chevy S 10 emergency brake can be adjusted with the emergency brake adjustment bolt. The adjustment bolt will be on the emergency brake pad.
Bad switch on the emergency brake handle.
Purchase a repair manual for that vehicle from your local auto parts store if you are not familiar with brake repair.
On a 1998 Chevy Blazer, the parking brake switch is located on the top of the parking brake assembly. There are 3 bolts that hold the switch to the parking brake assembly.
Directly above the brake pedal.
That's what I am asking you. How do you replace a parking brake handle on an S-10 1996 Chevy Blazer?