Iam trying to hook up a ele.brake controler on a ford 700 truck with air brakes cant find where yo hook the wire to send signal to controller
On the front of the truck by the tow hook
take the truck to your local ford dealer. they can hook up their scan tool and read the code.
were did the tow truck hook the cables at ????????
no, but with a truck you can hook up a oil rig.
The bulbs on trailer look good.Lights on truck work.Might be ground not sure.Looks ok.
Yes just get a truck that can hook trailers and find a trailer to hook and press left on the d-pad
To hook up stereo speakers in a truck, attach the stereo wiring to the stereo and run it to the speakers. Clip the stereo speakers into the wires and place them in the panel spaces in the truck.
Yes, you can hook up a car seat to the Ford Expedition
The tow truck driver must make sure that the 4x4 is disengaged (if it is 4x4) first of all. Then they have to put it in neutral so it will coast behind the tow truck. Since Ford Explorers are rear-wheel drive, you must hook up from the rear wheels, so the front wheels can spin easily.
It can be either. As a verb (action word): I will hook it onto the truck As a common noun: My coat was hanging on the hook.
With bolts or weld.
you need to hook it up on the distributor
Depends on what year it's from. On an older truck, hook the positive to a positive battery post, hook the ground to a bolt which goes through the chassis. On a newer truck, which is apt to having chassis-mounted electronics, put the ground to the negative battery terminal.
if you have a plug on the back of your truck then there is a blue plug over top of the emergency brake pedel on top of the 50 way wire harness and your truck should have came with the plug for the electric brakes in the glove box and the wires are marked as to where they go where you hook them to your trailer brake controller i hope this helps you Allen if you have a plug on the back of your truck then there is a blue plug over top of the emergency brake pedel on top of the 50 way wire harness and your truck should have came with the plug for the electric brakes in the glove box and the wires are marked as to where they go where you hook them to your trailer brake controller i hope this helps you Allen
trying to hook up an aftermarket 7spade receptical so I can have light, turn, brakes,hazards if I had factory specs on there wire colors and function I could go from there
hand operated vacuum pump . hook up and and apply vacuum and open bleeder and keep applying vacuum then close bleeder. repeat x4
They have to be towed by a helicopter
Go to www.productsamerica.com. They have tons of crib hardware including the "s" hooks for the springs.
You can hook up an MSD Digital 6AL/6A on an 84 Chevy truck by first replacing the original cap, and rotor if they are worn out.
How to hook up tow bar to 2004 mustang
each car different, throttle lever on carb to bracket.
you have to hook it to your computer with the uv chord and update it (only if you get red and blue lines)