It isn't feasible to convert from two wheel drive to four wheel drive.
NO, The frames are made different.
It is located on the top of the valve cover, towards the back of the engine, under the upper intake plenum.
Loosen the tensioner pulley. Remove the old drive belt. Install the new drive belt. Tighten the new drive belt with the tensioner pulley.
36 millimeter on 2wheel drive
Around 4000 lbs.
No , a 1994 Mercury Cougar is rear wheel drive
Buy a tester.
Yes , the 1999 Mercury Cougar is FRONT wheel drive
Replace the head gasket for sure. That is assuming you did not continue to drive the vehicle until you destroyed the engine internally.
6 lug same as Nissan,Toyota
To replace the clutch you must separate the engine and transmission. For a front wheel drive vehicle, separating the engine and transmission can only be accomplished by removing the engine.
Pull the engine.
On a Mercury Cougar : ( 1999 to 2002 model years are front wheel drive ) Older model years are rear wheel drive
Chances are, the wolverine would drive the cougar away. But in a fight to the death, cougar wins.
NO it will not. The center shaft in the 2-wheel drive transmissions are shorter then the 4-wheel drive transmission cause there is no need for a transfur case on the 2-wheel drives.
no it is defently rear wheel ================================================== That would depend on which model year , there have been rear wheel drive and front wheel drive versions of the Mercury Cougar
Ford Explorers are either rear wheel drive , 4x4 ( that has a LOW RANGE ) for the transfer case , or all wheel drive ( which does not have a low range ) * up to the 2010 model year *
yes. you need to take out the front end and bolt it on. then take out te transfer case and front drive shaft.
what is the engine size? That is missing information. Are you asking about the ignition system? If you are, I can give you the exact information from a the Haynes Ford Ranger & Bronco II 1983 thru 1992 2WD and 4WD models with a gasoline engine Repair Manual if you give me this tiny bit of information
Tighten bolt on shifter
first we need to know the year of the truck and the engine size before answering your question. all of the other things like a/c, 2wheel drive or 4 wheel drive is not needed. What kind of scanner are you using? Give me the scanners make and model and I can help you with the answer or you can go on-line for the code description..