had to do it on my 2000 f-250 because the hot wire to the over drive switch will short out. Remove the screws under the wheel holding the plastic around the steering column Insert the ignition key into the switch and turn it on-not start-just on On the underside of the ign you will see a small hole-put a small screwdriver into the hole and push while pulling out on the key and ign mechanism only goes back in one way because of a groove in the cylinder Hope it works for you----- jim-----
Begin by removing the retaining ring at the top of your 1994 Ford ignition lock cylinder. The ignition lock cylinder will slide out. Remove the wiring harness from the end of the ignition lock cylinder. Reverse the process to install your new ignition lock cylinder.
Remove the retaining ring, from the top of your 1997 Ford Astro ignition lock cylinder. Remove the wiring harness from the back of the ignition lock cylinder.
Removing a ignition lock cylinder from a 2002 ford windstar with no key
how do I remove the key switch from a 1998 ford contour You have to remove the plastic trim around the steering column (behind the steering wheel). Put the key in the ignition cylinder and turn one click. There is a small hole on the side of the ignition cylinder, stick a small screwdriver into this hole and press hard. Pull out the ignition cylinder with the key.
There will be a pin on the front bottom of the cylinder housing. Turn the key to the on position then push the pin in and pull the cylinder out.
15 gallons
yes you do have to remove lock cylinder:first turn it to the off position and then under column is a hole.Take a pick or coathanger ,bend it straight to go inside hole and press against cylinder release button and pull cylinder out
CK. with ford dealer............
rip it out or call a locksmith it happened with my 94 tbird
if it is a dohc engine then you may have to remove the intake manifold
How do you remove ignition tumbler 1998 ford Mustang?
yes