Don't know what model year your truck is but for 1994-2005 B-series Mazda pick-ups, open the tailgate and remove the lamp housing screws; take the assembly out of the fender; rotate the bulb socket to align the lugs and take the socket out of the housing; carefully pry off the retaining clip and pull the bulb out of the socket; installation is the reverse of the removal steps. - Haynes Reapair Manual #36071.
How do you remove cover to replace brake light on 57 kia Rio
You have to go inside the trunk and remove the circular plastic covers from behind the lights. Then you have to unscrew the entire light and you can access the bulbs to replace them.
push it forward the it should come off
you have to kneel on the back seat and remove the cover from the rear deck.the bulb socket is turned counterclockwise and the bulb can be replaced.
I own a 2006 Mazda Tribute I. I am not a mechanic but I recently adjusted my E-brake, and this what I discovered... The E-brake adjustment nut is located under the E-brake leather cover (directly to the left of the E-brake lever). You have to remove the E-brake cover and tighthen the bolt to the proper adjustment.
Pop the trunk, behind where the brake lights are, there is probably a plastic/rubber cover with screws in it, remove it, and then there should be some screws holding the lens in place, remove those, pull the brake light lens from the outside of the car, twist the wires to undo them from the lens, and go from there.
you remove plastic red/white cover with 2 screws and remove bulbs.
Remove the plastic cover on the outside and just pull the bulb out
To replace the rear brake lights on a Nissan Primera first open the trunk lid. Locate the tail lights and find the plastic cover which hide the bulbs. Remove the cover and then the bulb. Replace with a new bulb.
Jack up the Odyessy. Remove the wheel and the brake caliper. Take the brake rotor off. Remove the axle nut cover, and the cotter pin. Remove the axle housing. Replace the inner and outer bearings as well as the races.
there is a plastic cover above the tail light held on by two screws. remove that and simply pull the tail light out.
Get in the back seat and grab the rear brake lite and pull the cover toward you. Bulbs are then remove able.