most all window crank handles these days are the same, look just behind the handle where it meets the trim panel and you should see a metal clip passing through the handle plastic. With a small hooked tool grab the end of it and pull towards the knob.
You will need to remove the inside door panel of your 1999 Ford Escort. Loosen the retaining clips on the window. Remove the window from the window track. Reverse the process to install the new window.
take the door apart remove all old parts and replace its just that easy
You will need to remove the inside door panel in your 1989 Ford Mustang. Remove the window retaining clips. The window will lift out. Reverse the process to install the new window.
you can
Remove inside door handle and window crank handle, remove inside door panel, remove vent window and channel assembly, remove window.
Remove the inside door panel or cover and look inside the area where window is concealed and turn the manual window knob. If no problem is detected, check through the car's other window. Use open-end wrenches or a socket wrench to replace worn or broken parts or tighten loose nuts and bolts.
Disconnect everything and pull it out if it is like a manual 1991 ford escort
Remove the inside door panel of your 1982 Chevy Corvette. Remove the window retaining clips. The window will lift out.
You have to remove the door trim on the inside of the door. Also remove the window crank handle if it is manual windows. 1. remove the window regulator by unbolting the regulator from the door shell and sliding the window guide arms out of the window channels. 2. You then remove either side or both sides of the vertical window channel that the window goes up and down on. 3. Finally, most of the time you need to remove the window rubber seal that runs horizontally along the bottom of the window opening to get the glass and the regulator channel that is attached to the glass out of the door.
The 1996 Ford Escort inside door panel is held in place by eight retaining clips. Pry outward on each retaining clip to remove the door panel.
Disconnect negative cable at battery. Remove the inside door trim panel, remove film watershield, remove the door window glass assembly by lowering the window all the way, remove inside door handle and rods, unplug electrical mirror and regulator wires, remove the glass stabilizer bolt, then the 2 window glass retainer bolts, lift out the window glass, then remove the 4 regulator assembly bolts and wiggle the regulator out thru the opening. Reassemble in reverse order. Buy a Haynes Repair Manual for about $15 and save yourself some anguish! YFC
Begin by removing the inside door panel. Remove the linkage from the window winder. Remove the window winder retaining bolts. The window winder will come off.