Under the hood -It's mounted on the evaporator case on the Passenger side-There are 4 screws in a square pattern-they are about 4 inches apart-remove the rubber vent hose-little ground clip on one of the screws & the 12 volt power wire-BE sure 2 use calking 2 reinstall the new blower motor after u install the blower fan (Squirrel Cage)
Its should be behind the glove box.. held in by 1 screw
how do I change the heater blower on a f350 2002
Remove the water supply hoses from your 1992 Chevy S 10 pickup truck heater core. Remove the heater core retaining bolts. Reverse the process to install your new heater core.
First, take a socket wrench to remove the cover of the blower motor of a 1993 Chevy truck. Then pull the motor blower out and install a new one in its place. Lastly, screw the bolts of the blower motor cover back in.
Only for the high speed blower function. The lower speeds go thru the blower motor speed resister.
replace heater core in a 1991 Chevy work truck 1500
you need the special tool its about 30 bucks from snap on
If you are asking about the blower you only have one that controls both the heater and the a/c............
need diagram for heater core for a 1994 Chevy truck.
The blower resistor on a 1999 Chevy truck Z1500 is located behind the glove compartment. There is also a resistor on the firewall next to the blower motor itself.
the blower motor is located on the passenger side firewall under the hood remove 3 or 4 bolts and the motor will come loose
This is not easy. Get a manual from AUTOBOOKSONLINE.COM It is under the dash on the passengers side of the truck. You shouldn't have to remove the whole dash.
In the truck!
On the Dodge Ram truck, the heater fuse for the blower is on the fuse panel on top of the battery. There is also a blower motor resistor on the blower motor. The fuse to control the heat control panel is in the fuse box in the dash.
Sometimes switches wear out, which could be the reason the switch in your 1992 Chevy truck is not working. There could also be a problem with the wiring. You may also want to check the fuse for the blower to see if it's bad.
Need to know what year and model the truck is. 1992 Chevy k2500
You may have a vacuum leak
First you must access it from under the dash, take the plastic cover off of the fan and the heater core. It gets tricky cause of the screws are hard to get too. once you get the cover off, you probably will need a 90 degree screw driver or a small rachet with a tip to remove the motor.
it is under the glove compartment on the passenger side of the truck
From the inside. you have to unbolt heater box
The blower motor can be replaced on a 1995 Chevy truck by first disconnecting the battery. It helps to take a picture of the blower motor before dismantling, so that it can be put back easily. Disconnect all the wires from the motor, then remove the bolts holding it to the firewall. Replace with the new motor and bolt it in, then connect the wires. Reconnect the battery.
they are usually found close to the blower motor.
you sell the truck
You will have to remove the whole instrument panel. Then lower or remove steering column. Then disassemble heater case. Best taken to a dealer due to possible steering column issues, not impossible though. is it the same as a 1998 heater core replacement