Want this question answered?
If your key is stuck: on the underside of the steering column cover there is a round recess cover. Remove the cover and using a pecil push up through the recess.
What do you mean by headlight cover?What are you trying to do?JW
You need to remove the rear seat to access the speakers and remove the covers.
remove the spark plug cover. and the valve cover to reach it its right under the cam pulley
The ignition coil is down between the firewall and the back of the engine
open trunk remove carpet over taillight remove retaning screws
Im not familiar with grand ams with the 2.3L having TFI. That's a ford thing more like. But nonetheless the 2.3L grand ams used direct ignition and the ignition module is bolted to the direct ignition plate above the valve cover. This is the cover that says 2.3L Quad OHC. To remove this there is a harness connectopr that enters the side of this plate. This is the harness for the ignition module, so if you can find this harness then you found the module. There are a few bolts on this top cover. Remove them and then the cover should pull up. The plug boots wuill come with this whole assembly(hence the direct ignition name, no plug wires involved.Let me know if you need any more information.
Remove the instrument panel,take cover off on the front of the lock cylinder there are two 10mm bolts that mount it & remove it through the hole were the cluster sits..GM tech...
where is valve cover located on a 2001 Pontiac Grand-Am 4 cyl
The 1995 Pontiac Grand Am 3.1 liter engine crank shaft sensor is located inside of the rear engine cover. You will need to remove the rear engine cover in order to access the crankshaft sensor.
Follow the upper rad hose to the engine. You will need to remove the engine cover. To remove the cover turn the oil filler neck (not the cap).
To replace a Pontiac Grand Am bumper cover, start by taking out either the three bolts on the side of the fender or in front of the wheels. Remove the top pushpins to remove the cover. Push back the two pins for each headlight, and pull them up. Unplug the lights. Then, get the replacement bumper, and snap it into place like the previous one.