Be the first to answer!
what is a 1998 olds moblie cutlass value
go to BEST BUT and spend 69.99
how do you replace a starter on a 1998 cutlass
I have a 1998 olds cutlass and it is leaking cooling and have a bad ticking sound what do you think I should do.
Take out the fuse.
i dont have a answer i want a answer
Need to know a few things about your olds. What type of Cutlass is it? Engine size? This will make for a better answer for you. Need to know a few things about your olds. What type of Cutlass is it? Engine size? This will make for a better answer for you.
where is the emc located on a 1988 olds cutlass?
The headlight assembly on a 95 Olds Cutlass Ciera is removed by disconnecting the wiring harness and removing the bulb. The assembly can then be unbolted and removed from the vehicle.
Use a 10mm socket.
get large gun out, shoot car.
Where is the water pump on a 1995 olds cutlass supreme?"
how do you drain s 1999 olds cutlass radiatoe
Use a sparkplug socket and turn counter clockwise
i need to replace the ecm on a 1993 olds cutlass supreme,can i replace it with another ecm from another olds cutlass?
It takes a pulle r available from the parts store for rental.
Remove the wiper arm from your 1999 Oldsmobile Cutlass wiper motor. Remove the wiper motor wiring harness. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.
On a 96, there is a fuse panel on the right side of the dash, against the right door.
The last rwd Olds Cutlass was the 1988 model.
You will need to remove the intake and the exhaust manifolds and then you can remove the heads to replace the gaskets.
To remove the radio. 1. remove the ashtray, and 2 corner vent diffusers. There are bolts to remove in ashtray area and inside Left/right most vents. 2. remover the rubber steering wheel trim ring. then remove the whole vent diffuser assembley. 3. remove the 4 screws at the top of the instrument cluster. and the 4-5 at the bottom. (covered up by the vent piece).
First you'll need to remove the trim panel covering the radio. Remove the support plate holding the radio in place. There are pre-built wiring harness kits that will make the installation much easier. Remove the old radio and disconnect the wiring. Attach the new wiring kit to the new radio, and attach that setup to the wiring in the car. Seat the radio propery and make sure it's bolted in place to avoid making the CD skip when you hit bumps. If the new radio is not secure, it will skip. Reattach the support plate and put the trim panel back on, and you're done. Disconnect the car battery to work safely on this project.
An exploded view of the heater controls for a 1989 Olds Cutlass can be found in the Cutlass service manual. The manual can be found at most auto parts.