try to look on the back inside of the rotor (right where the shaft goes in) and there should be a seal pressed against it. Pry that seal off and you should be able to pull the rotor straight off. If not, make sure that seal is removed and beat and pry the rotor until it comes off. If you have to do this, it is usually means you have a bad inner bearing. The bearing will need to be replaced. Pull it off the shaft with a three jaw puller.
you have to remove the entire head-light/turn-signal assembly to get to the bulbs. There are these plastic clips on either side of the ENTIRE asembly, just pull them up and the entire assembly comes free. Remove the rubber stoppers on the back and then you need to twist the bulb housing to remove it from the asembly. The bulbs themselves just pull out.
How do you remove the flywheel on a 1999 ford ranger
How do your remove the dashboard on a 2000 Ford Ranger?
you have to remove the entire head-light/turn-signal assembly to get to the bulbs. There are these plastic clips on either side of the ENTIRE asembly, just pull them up and the entire assembly comes free. Remove the rubber stoppers on the back and then you need to twist the bulb housing to remove it from the asembly. The bulbs themselves just pull out.
Does anyone know how to remove the chrome part of the front bumper on a Ford Ranger XLT
you have to go to the car fix to remove it
You can remove the steering will, on your Ford Ranger pickup truck, by removing the steering wheel pin. Remove the wiring harness and the steering wheel will come off.
Cant Its the computer
is it front or rear
with a crowbar
do you have to remove fan shroud to access thermostat housing on a 1997 2.3L ford ranger
remove all the screws from the tail light asembly turn bulb to remove put electrical contact greas on new bulb install new bulb replace screws