Insert key into the ignition and turn to on. Don't start the engine. Put transmission in Nuetral. Remove the U clip from the shift knob with a small screwdriver. The slot is on the front of the knob towards the dash board. Once the U clip is removed, pull up on the shift knob and it will come off.
On the 2000 the knob is on a spline on the shift lever. You'll either have to cut it off, or if you want to reuse it take out the lever by unscrewing the nut under the shaft, place the shaft in a vise and pound off the knob with a soft hammer.
The switch is located inside of the frame, underneath the panel where the shift lever comes up. Remove the knob on the shift lever and remove 2 screws, and remove the plate. The switch is mounted below the Deck Lowering Lever.
To remove the gear shift knob on the SLK 320, first pry the cover from the gear shift knob. Then, use a screwdriver to remove the screw in the center of the knob. This will then allow the knob to be removed.
To remove the gear shift knob on the '03 Silverado, first pry off the cover that has the shift pattern on it. Then, remove the screw that is under that cover to remove the knob.
How do you remove the gear shift knob on a 2000 Daewoo Lanos?
First remove the shift knob pattern (it can be pried out with a small screw driver). Next remove the alignment pin with a pair of pliers. Then the shift knob can be unscrewed.
To remove the console shift knob on the AT 1993 Olds Achieva, first pry the cover from the top of the shift knob. Then, access the single screw inside the cover of the shift knob and turn it counter-clockwise to release the knob.
remove shift knob remove shift boot at the base of shift lever, there is a metal ring, push down, and turn it to the left. -there is a special tool to do this, but two flat head screw drivers work
pull the shift boot down. loosen the jam nut under the shift knob then unscrew the shift knob.
* Remove the shift lever knob,console and shift boot * Disconnect the shift and select cables from the shift control assembly * Remove the large shift cable retainer plate and detach the cables from their bracket on the shift control assembly base * Remove the shift control assembly retaining nuts and remove the shift control assembly
You simply unscrew the bottom "ring" of the shift knob and then lift the knob portion upwards.
There is a staple on the front of the gearshift just below the knob, remove it and lift the shift knob.