Start by pushing the car off a cliff. No, there are two 3/4" bolts on the backside of the caliper. Remove them. The next part is a bit harder. Get a punch and knock the roll-pins out. Be careful and watch the retention springs, they might go flying out. You might want to spray brake cleaner on everything first because there's bound to be brake dust everywhere. Any questions email whitethunder89@Yahoo.com
You can replace your brakes by bringing them into your local auto repair garage. If your car is still under warranty, you can also take it into your dealership for replacement or repair.
be more specific.. replace pads..?? replace hose..?? repair master cylinder..??
chiltons repair manual from the library for your car. on the computer daaaaaa
how do you repair an inner tie rod for a 96 Pontiac sunfire no repair,replace with new.
To repair brakes, you need to first decide what needs to be replaced. You may want to replace just the brake pads, or the brake lines.
To thoroughly replace and repair brakes, one must replace the brake light wiring, brake pads, and brake calipers. Furthermore, one should reline the brakes.
How do you replace front Brake Pads on E300TD
replace rear brake hydrolics
Brake cylinder repair is that wheel cylinder that holds the oil to keep your brakes running smooth on your back brakes. If you don't repair those you will mess up your rotors and your rims.
It is cheaper to replace the heater core than it is repair it
it wont stop. You will very likely push the seals out of the brake cylinder and have to repair or replace it and bleed the brakes
Replace the gasket with a new one.
It would probably cost at least $200. You should ask your local repair shop to specifically find out how much it would be to replace the brakes in your Toyota.
This is a major repair requiring the removal of the intake and exhaust manifold, and then the removal of the heads. Not a DIY repair unless you have the knowledge, and tools necessary to accomplish this repair. If you want to tackle this job, I suggest you buy yourself a repair manual for your Pontiac.
If the the brakes replace from a dealer for the front brakes including re-surfacing the rotor disc is.......$420.00
You can replace an exhaust clamp with a new one.
YOU CAN USE ANY REPAIR MANUAL FOR A PONTIAC 71 THRU 81. GO TO YOUR LOCAL PARTS STORE THERE IS A HAYNES MANUAL FOR BUICK,OLDS,AND PONTIAC FULL SIZE.EVERYTHING YOU NEED TO KNOW IS IN THERE.
A repair shop can release a car with bad brakes if they were not asked to repair the brakes or the customer refused service. It is then the responsibility of the customer to have them repaired.
Replace the pads, and the rotors. You need to change the brake pads and the rotors.
There are some mechanics that do know how to repair car brakes. If you wanted to find out who repair car brakes, you can ask around in the neighborhood or ask a family or a friend.
Pick up the Haynes repair manual, it goes through the process step by step. I found it through Amazon.com. I am about to replace the one on my 2001 Pontiac Montana. Good Luck
It would be to your advantage to take your car to a Brake Repair Shop if you have to ask that question brakes are not something you should do if you do not have the skill, WBMS
autozone.com current vehicle upper left choose car repair info vehicle repair guides hope u find it from there
This is as complex procedure. I suggest you buy a repair manual if it is not obvious to you, and you don't have experience.
One good nationwide company is Auto Zone. They can do anything to brakes, repair them, replace them, clean them, etc. They would be my first choice.