answersLogoWhite
Acura Integra
Pontiac Fiero
Chevy Blazer S-10
Honda Accord LX

How do you repair or replace the selector cable on 1985 Fiero GT V6 4spd?


Top Answer
User Avatar
Wiki User
2008-06-30 11:54:34
2008-06-30 11:54:34

Remove the center console (glovebox) and shift surround. Then disconnect the battery. Remove the computer and the computer mounting box. Remove the two rear bolts holding the skeleton in place. Disconnect the cable at the trans. and at the shifter and mark the positions. Carefully raise the rear of the skeleton and pull the cable out the back side of the skeleton then pull it and the rubber grommet from the engine compartment. Install in reverse order.

Related Questions

User Avatar

No repairing the cable. Replacement is the only option.

User Avatar

Fiero does not use a speedo cable There is an electronic sensor mounted on top of the transmission that both the engine computer and the speedo in the dash read to get the speed.

User Avatar

Fiero does not use a speedo cable There is an electronic sensor mounted on top of the transmission that both the engine computer and the speedo in the dash read to get the speed.

User Avatar

form_title= Cable Modem form_header= Repair or replace your cable modem. Do you need to replace your cable modem?*= () Yes () No What is your budget for a cable modem?*= _ [50] Do you need help with the repairs or installation?


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.