answersLogoWhite

0


Best Answer

The following instructions are for a 3.1 L V6

1: Disconnect your battery.
2: Elevate car to where you are able to easily get under it.
3: The starter is located on the bottom of the engine right behind the radiator; Center of the engine on the front (grille) side.
4: Remove oil filter.
5: Remove wiring harness directly beside starter.
6: There are two bolts located on the starter, both should be 14mm. Remove bolts and hold starter up.
7: lower starter and disconnect wires, large then small.

Add new starter in reverse order.

Don't miss a step, don't try to skip a step. I've tried every alternative, they don't work..

Cory

User Avatar

Wiki User

โˆ™ 2009-12-04 20:57:44
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace a starter on a 1993 Chevy Cavalier?
Write your answer...
Submit
Related questions

How do you replace the fuel filter located on a 1993 Chevy Cavalier?

i need to find location of fuel filter on 1993 Chevy cavalier


How do you replace the starter on a 1993 Chevy Cheyenne?

Remove the positive battery cable from your 1993 Chevy Cheyenne battery. Remove the two cables from the front of the starter. Remove the three starter retaining bolts. Reverse the process to install the new starter.


How do you replace starter 1993 88hp Johnson outboard?

how to replace starter 1993 88hp Johnson outboard


1993 cavalier vl spark plug gap?

1993 Chevy cavalier 2.2l Spark gap is....................... 1.4mm


Where is the starter located on the 1993 Chevy Cavalier V6 2door?

Your Starter is located at the front of the engine near the transmission. You need to take off two wires running to the starter and then two bolts holding it on. It's very easy.


How do you override a Governor on a 1993 Chevy Cavalier?

What governor?


Where is the starter located 1993 Chevy Camaro?

The 1993 Chevy Camaro starter can be found on the right hand side of the engine. You can follow the positive at three cable directly to the starter.


How do you replace a starter in 1993 Chevy Caprice classic?

Disconnect the battery. Remove the wires from the starter then unbolt it. Lower the starter, then fit the new one in. Bolt up the starter and connect the wiring. Reconnect the battery.


Starter relay location on 1993 Chevy truck?

on top of the starter


Where is the neutral safety switch on a 1993 Chevy cavalier?

The neutral safety switch, on your 1993 Chevy Cavalier, is located beneath the shifting column. The switch can be accessed by removing the shifting boot.


How do you replace a starter on a 1993 Toyota Celica?

bolt pattern for 1993 toyota celica starter


How do you replace the starter on a 1993 Chevy Camaro?

Get under the car, find the starter, take 2 bolts and some wiring off, put the new one on in reverse order.


How do you install a starter on a 1993 Chevy Corsica?

Begin by removing the positive cable from your 1993 Chevy Corsica battery. Remove the cables on the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.


Why does Water drip under 1993 Chevy Cavalier?

Because your fail


How much does a 1993 Chevy Cavalier station wagon cost?

$15,000 .00


Where is fuel filter located on 1993 Chevy Cavalier?

Behind the gas tank.


Does a 1993 Chevy cavalier z24 have a timing chain or belt?

Timing chain.


How do you change the headlight switch on a 1993 Chevy Cavalier?

pull the steering column off and I can't remember if it a pin or screwed in because it is also the turn signals. and replace the stalk.


How do you remove the ignition module on a 1993 Chevy Cavalier?

it is located behind the coil packs


What is the spark plug gap measurements for a 1993 Chevy cavalier rs?

0.045 inch


How do you remove the stereo from a 1993 Chevy z-24 cavalier?

purchase Haynes manual.


What is the lug nut torque for a 1993 Chevy cavalier?

My book says 100 lbft.


How do you remove a starter for Chevy Camaro v8 93?

Begin by removing the positive cable from your 1993 Chevy Camaro battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. The starter will come off.


How do you replace a starter on a 1993 Chevy Camaro 3.4?

disconnect battery. from underneath disconnect battery and solenoid wires from the starter.remove starter motor bolts and note the position of the spacer shims. installation is the reverse making sure to replace the shim in the same position if so equiped.


How do you replace a starter in a 1993 mercury capri?

Remove the positive cable from your 1993 Mercury battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.

Study guides

๐Ÿ““
Create a Study Guide