Just follow the top radiator hose to the engine and it will clamp on a housing
Remove hose, then take the 2 bolts out of the housing. and the thernostat
will be under the housing. clean old gasket off and install new thermostat
and gasket. Install housing and tighten the 2 bolts evenly a little at a time.
Put hose back on, fill with coolant.
BE SURE ENGINE IS COLD AND DRAIN COOLANT FIRST.
4L60/E l
Don't know what year you have but some sensors are temperature sensitive and you should run a 195 degree thermostat.
.043
.43L. 1000ml=1L
43L of 18-k gold
Yes it will bolt right up to it.
There is one before and one after the catalytic converter.
The fuel lines around the filter; you will need an adapter.
There is no adjustment required, but you can clean it with a carb cleaner.
Use an exhaust made for an LT1 engine the blocks are identical it is the insides that is different. Will bolt right on.
remove the intake hose and the exhaust port screwed into the egr valve, the remove the two retaining bolts from the intake and clean any old gasket material away. if possible run a piece of wire down the hole to make certain the passage is clear of carbon build up
It should be on the front of the intake manifold directly above and behind the water pump.