Be Careful Doing This. Get A Good Rust Removing Penetrating Spray +++++++++FORGET WD40 This Is Junk. Get CRC Or Another Good Brand. Get A Good Six Point Wrench That Fits The Bleeder Screws. Soak Them Down With The Penetrating Fluid. Several Times. Easily Try To Remove Them, Be Sure Not To Break Them Off. If You Happen To Do So. You Will Have To Replace The Wheel Cylinder. Take Your Time You Should Be OK. GOOD LUCK
Replace wheel cylinders
Disc brakes at the top of the caliper Drum brakes at the top of the wheel cylinder
Bleeder screw for clutch is at the slave cylinder, on the bell housing of the Transmission. The bleeder for the brakes is on the calipers, and on the backing plate of the rear drum brakes
This will greatly depend on what kind of brakes you have and which parts you are trying to replace. Do you have disc or drum brakes? If you have disc brakes, do you want to replace the calipers, pads, or rotors? If you have drum brakes, do you want to replace the drum, or the shoes?
There are 4 sensors on the 1995 Chevrolet Blazer. The 2 front for the Disc Brakes is behind the rotors on the hub. The inside hub has gears and the sensors are above them. On the rear, where you have Drum Brakes, the sensors are on the back of the Drum Brake Assembly, next to the bleeder screws.
The bleeder valve for the brakes on a 1997 Ford Ranger is located in the brake line where it meets the brake disc. The wheel will have to be removed to access the bleeder screw for drum brakes.
located on each brake caliper/wheel cylinder for drum brakes. have an assistant pump brake pedal several times then hold down. open bleeder valve. repeat on each wheel until only fluid comes out. top off master cylinder as required. I suggest using line wrench on bleeder screws.
Drum brakes are one of the easiest brake jobs to preform, but remember you may have to have your drums professional turned or possible replace them if warped.
If the brakes are disc brakes then try opening the bleed screws on the calipers and see if the pressure releases if not then remove the calipers and replace because the piston is probably frozen or you can try pushing in the piston with a c-clamp,if that doesnt work replace the calipers as noted. If the brakes are drum brakes then check your brake cylinders to see if they are leaking if so you can usually rebuild them if not then replace them and bleed your brake system to get brakes back to normal, you can also make sure your drum brakes are adjusted correctly.
Yes on most vehicles.
Check related links below for drum brakes.
First, determine if they are disc or drum. If drum, remove the drum and replace the shoes. If they are disc, remove the caliper (and disc if necessary) replace the shoes and reassemble.