This question was asked and answered earlier, so please search for a more complete answer. You need to peel the liner from the trunk lid, reach in to access the bulbs. The bulbs are bayonet base type.
It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.
Same circuit/fuse as the parking/tail lights.
to wire the license plate lights you must have lights and wire them to the scooter.
there should be 2 screws above license plate, take the off piece pops off and replace lights
Possibly a bad ground in the rear wiring harness somewhere.
No, the license plate light is wired in with the rear tail lights, not the brake lights.
Open the trunk and look for the wires that connect to the license plate lights. You should see a plastic piece that hooks into a socket. Simply grab the plastic piece and turn and the lights should come right out. The lights may be behind a paneling.
Oldsmobile stopped making Alero in 2004 and GM stopped making Oldsmobile in 2004, so some mistake here?
There should be a connector for the lights above the rear bumper, but you may not want to disconnect it because then your likely to get pulled over for having a faulty license plate light
Open up your trunk and look up above the license plate. It is held in by screws. undo the screws adn unit drops down.
Raise the trunk lid...you will see the lights on each side of the license plate...use Phillips screw driver to remove and replace bulb. Just did this takes about 2 minutes.
The license plate lights are not in a separate fuce by it seft. They are the same as your side marker lights. So, check if your side marker lights are working and if they are them is a bad license plate light bulb.