You can find a camshaft positioning sensor and any other Daewoo parts through Lipscomb Mitsubishi. How to change it I don't know if anyone has the answer please E-mail me
--I have a 2000 Nubira (2.0L engine) and the camshaft position sensor is located inside the timing belt cover, on the passenger side of the engine, and behind the timing belt. The right engine mount bracket has to be removed so make sure you support the engine first--the alternator seems to have a pretty stout bracket to place the support under. The sensor is located towards the very top, behind and between the two camshaft sprockets/gears.
The camshaft position sensor is located on the end of the camshaft housing, on a 2002 Daewoo. The sensor should be labeled as such.
The camshaft position sensor is located in the engine compartment of the 2002 Daewoo Leganza. It is at the end of the camshaft housing.
In order to replace the camshaft position sensor, you would need to disconnect the electrical plug holding it in. Using a socket, hold down the bolt and remove the camshaft position sensor.
On the 2000 model it is part of the distributor and you either replace complete distributor or try to dismantle the distributor and replace sensor only.
how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l
I started by removing the camshaft cover, then I realized the many other parts have to be removed before being able to succesfuly replace the sensor.... I also would like to know the procedure. Thanks
where is the camshaft position sensor located on a 1999 Oldsmobile intrigue
how to remplace position of oxigen sensor
How do u replace the camshaft sensor for a 2000 Nissan xterra 3.3L and where is its locatoin
I changed only the camshaft position sensor on my 2000 Kia Sportage. So I don't think so.
do you need to take off the timing belt to replace a camshaft position sensor on a 2006 kia sorento
The camshaft position sensor is located near the thermostat housing. You should replace the crankshaft position sensor as well. This one is much harder to locate....it is on the backside of the engine that is between the firewall and the engine block. Both use the same sensor.
the camshaft position sensor is on the left side of the engine , at back on the upper side . you have to demont the conector , than unscrew and replace it
If I'm not mistaken, I think the camshaft position sensor on these engines is built into the distributor. You'd have to replace the whole thing.
It is located on the backside of the engine. Go to youtube and type in how to replace camshaft sensor on 2005 Nissan altima and it will show where it is and how to replace it, that is how I did my one.
Where is the camshaft position sensor on a 2005 Expedition?
The 1995 for Crown Victoria camshaft position sensor can be found on the back of the cylinder head. The camshaft position sensor will be labeled as such.
location of the camshaft sensor
in the distributor, you have to replace the whole unit.
Camshaft position sensor circuit malfunction.Camshaft position sensor circuit malfunction.
Yea, the crankshaft sensor is under the distributor and the camshaft sensor is inside the distributor, you cannot change it so you will have to replace the whole distributor.
Do you have a video of the hhr camshaft position sensor
CMP-camshaft position sensor CKP-crankshaft position sensor
The Pontiac 2.2 liter engine camshaft position sensor can be found on the back of each cylinder head. The camshaft position sensor should be labeled as such.
There isn't a camshaft position sensor. If you are asking because of an error code you received, it is caused by a signal that mimics the same signal as a camshaft position sensor.