Chevy Malibu
1995-1999 Dodge & Plymouth Neons
VW Passat
VW Sharan

How do you replace the license plate light bulb for a 1997 Malibu?

252627

Top Answer
User Avatar
Wiki User
Answered
2006-10-20 00:46:10
2006-10-20 00:46:10

To change that bulb push the bulb down and turn to take out you may need to unscrew the cover first and replace it with the same bulb

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


How do you replace the license plate lights on a 2000 celica?

yes there is, just above rear plate.

how do u change the license plate light on a 2005 sienna

how do you replace license pate light on 2006 pontia g6

The license plate light and connected right above the plate on a 2002 Volkswagen Beetle. To replace it just unscrew the old light and mount the new bulb.

Unscrew license plate and remove to expose light fixtures. Wedge light module away from holes. Replace them and return them to sockets.

It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.

How do you change the liscence plate light fuse

take off the license plate then screw the holder on with the plate.

as far as i know ,there is no fuse, it works off lighting curcuit.

You can replace the license plate light bulb on a 2002 Ranger by reaching under the rear bumper and pulling out the light socket. Remove the bulb and put the new one back in.

The easiest way i figured out was take the plate off the lights are vertically installed so open the trunk and remove the license plate. See sources and related links below for license plate bulb information.

unscrew the bulb in the opening above the rear license plate holder- bring the bulb to an auto parts dealer then replace the bulb

The license plate light on a 1995 Olds Cutlass Supreme can be replaced by accessing the bulb through a hole in the bumper next to the license plate. A person may need to do this from underneath the vehicle.

The license plate bulb is located right above the plate on a 2002 Oldsmobile Bravada. To replace the light simply remove the old bulb and install the new one.

You have to remove the liner from the inside of the trunk lid to remove the light.

in back above liscense plate,there should be 2 screws undo these screws, and pull out assembly to change bulb.

Superdiscount LEDs has a tutorial out how to change the license plate light to an LED light. Its pretty general how to do but a lot easier with pictures. Heres to step by step links that should help you! http://www.superdiscountleds-how-to-install-leds.webs.com/ -OR- http://www.go-audi.com/14083-audi-q5-how-do-i-replace-license-plate-bulbs.html Source: www.superdiscountleds.com

Remove the screws from the lens covering the bulb, pull out the bulb and replace it.

there are two spots above the license plate where the lights go on each one there should be a spot where you can push the cover in and then just pull out at an angle

The license plate light circuit is protected with the tail light circuit fuse.

You can replace the license plate light on a 2001 Lincoln Is by carefully prying the bulb holder and turning the light counterclockwise while pressing down on it. The bulb will loosen and then can be taken out. A new bulb can be screwed into the bulb holder by turning it clockwise.

To change the license plate light on a 2002 Geo Tracker, remove the light lens with a small screwdriver. Take out the old bulb and replace with a new one. Tighten the screws on the light lens.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.