special socket or get creative with a crescent wrench, also a standard socket may fit also
Everyone should have a manual for their vehicle, and the library should have a professional shop manual available in the reference section(make copies of the right sections) read up and fix it like a PRO! :) good luck
How to change oil pressure sensor on 3.4 sfi
under the throttle body.
Next to the oil filter
Need a little more info on what your trying to replace. Is it the switch in the dash? It's in the overhead console.
On my 2001 it is part of the Hazard switch. You have to replace the entire switch on a 2001.
How do you replace starter on2.3 cy 1991 pontiac grand am
how do I replace water pump 2000 Pontiac Grand AM SE1?
how to replace lifters on a 03 grand am
Pontiac Grand ams dont have an inertia switch, actually no GM cars that i know of have them.
Begin by removing the wiring harness from your 2000 Pontiac Grand Prix transmission pressure solenoid. Remove the solenoid retaining screws. Reverse the process to install your new transmission pressure solenoid.
If it looks the same it will probably work.
The switch is on the steering column about 18 inches from the floor under the dash. There are 2 screws that hold it on.
My turn signal switch died on my 92 Grand Prix. Rather than attempting the repair, I took it to a shop. The steering column had to be removed to get to the switch.
how do you reset the tire pressure warning light on a 2004 pontiac grand prix
how do i replace a water hose in 1993 pontiac grand am
1996 2.4L Pontiac Grand AmWhat year, engine, model?
change front coil spring on 2000 Pontiac grand am
how do you replace backup lights on 99 grand am?
There is a resistor pack operated by the fan switch. It has failed. You need to replace it.
"How do you replace the fan control switch on a 2002 Grand Prix?"
I called Pontiac there is no cfuel cut off switch.
Where would I finf the relay switch on a 96 Grand Am?.
There is none, GM vehicles do not have an inertia switch.
On my 2000 Grand AM SE the switch is in the dash above the radio (behind the hazard indicator button). You can remove the plate covering this part of the dash by prying around the edges.