Cable run from back side of shifter to the tranny. The center console will have to be taken out, its easy to remove. Cable snaps into the bottom of the shifter mechanism. Hooks to the tranny with a shim type clamp. Located on drivers side below the break master cylinder. You will need to remove the intake hose from the throttle body to the air box. To include the airbox and filter. The cable has grommets that keep it secure and keep water and air out of the cars interior. You can email me at stewblank6669 at Yahoo, I can give you my number if you need to hear this explained. I work on these things. Butch
Replace shift linkage Replace shift linkage
Below
The shifter linkage might be jammed or disconnected. The shifting sensor, that detects if the brake is engaged, may be malfunctioning.
To change the shift linkage in an 1998 automatic Chevy Cavalier the shift linkage needs to be removed from the transmission and pulled from the cabin. The job requires removing the floor console to access the cable. After doing the so the cable can be snaked from inside the cabin, the install is the reverse of the removal.
To change the shifter cable on a 1998 Oldsmobile Silhouette, first you need to disconnect the cable from the shifter, then disconnect it from the engine's control arm. Then replace it with the new cable and make sure it is functioning.
you have trouble in the gear box.. there is no linkage adjustment
The 1998 Honda Accord 3.0 liter engine does not have throttle cable. The automobile has throttle linkage. The linkage is connected at each end with a connecting bolt. Remove the connecting bolt to remove the linkage.
Which linkage.
good instructions in the manual. I just removed mine to have it welded.
First you have to remove the plastic around the steering column, two bolts hold on the lower plastic and two screws hold on the upper plastic from under the steering column once the plastic is removed you can access the three bolts holding the shifter assembly in place. You must first remove the transmission linkage As well as the selector linkage in order to get it free
You don't as it does not have a cable. You replace the speed sensor instead.
Sure. But I'm not sure exactly how. I'd check for you, but my Haynes manual is elsewhere right now. If you pick up a Haynes or Chilton manual for your car, it should detail that procedure for you.