answersLogoWhite
Auto Parts and Repairs
Starters and Ignition Systems
Nissan Trucks and SUVs
Toyota SR5

How do you replace the starter on a 1996 Chevrolet pickup with a 5.0 liter engine?

272829

Top Answer
User Avatar
Wiki User
2011-09-12 21:04:06
2011-09-12 21:04:06

Remove the neg battery cable. Then fp;;pw the pos cable to the starter and remove the wires from the starter/ Next, remove the mounting bolts and work it out among the exhaust and cooler lines.

1

Related Questions

User Avatar

The 1995 Chevrolet S 10 pickup truck starter relay switch is located on the firewall, in the engine compartment. The starter relay switch will be on the passenger side of the firewall.

User Avatar

Remove the positive battery cable from your 1988 Chevrolet 1500 pickup truck battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.

User Avatar

Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter

User Avatar

How do you replace a starter in a 1997 F-350 Turbo Pickup?

User Avatar

Starter is located on passenger side of engine. On the side of the engine at the bottom.

User Avatar

disconnect the battery, un bolt the starter and replace it then connect the battery

User Avatar

This is a tight fit. In order to remove the starter from underneath, you need to jack up the engine a little on the side the starter is on. This will allow enough room to slip the starter in and out of the tight spot.

User Avatar

The starter on your Chevrolet Colorado pickup truck can be changed by, first, removing the starter wires. Next, remove the three starter bolts. The starter will pull out.

User Avatar

Need to know what size engine you have in order to answer your starter problem. 1993 Nissan pickup with v-6

User Avatar

Check your cables for corrosion; if there is any,clean them or replace them. Clean the connections at the starter and clean all grounding wires; test the starter regardless if you think it is good. Clean the battery terminals.

User Avatar

attached to the battery. bolted to the engine

User Avatar

The Chevrolet Cavalier 2.2 liter engine will fit into a Chevrolet S 10 pickup. You will need to change the motor mounts on the Cavalier engine in order for the engine to bolt in properly.

User Avatar

It is screewed into the side of the engine block, Just in front of the starter on the passenger side. It is alittle hard to see.

User Avatar

Your starter solenoid is sticking. Replace the starter solenoid and you should be good to go.

User Avatar

Where can I download instructions for replacing the ignition switch tumbler on a 1984 chevy pickup?

User Avatar

go to auto zone.com and enter your vehicle year,make and engine size,then go to repair after looking up starter,it will tell and show how to remove and replace.

User Avatar

Look at the lower end of engine

User Avatar

What year,what motor?? it is a 2002 Chevy avalanche 1500

User Avatar

Lok at the lower rear end of the engine

User Avatar

top rear of the motor, next to the distributor


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.