Buick Century
Turn Signals and Hazard Lights
Chevy Camaro RS

How do you replace the turn signal switch located on a 1993 Buick Century?

293031

Top Answer
User Avatar
Wiki User
Answered
2008-01-02 02:25:28
2008-01-02 02:25:28

Disconnect battery ground and yellow air bag disconnect harness if so equipped. Unscrew the horn trim from behind. Remove center nut on steering wheel. Use a steering wheel puller to pull steering wheel. Remove some of the dash plastic to get at lower part of column. Unbolt the 2 bolts on the column support. Unscrew the 2 or 3 torx fasteners that hold the switch in place. Unplug the switch from the harness midway on the column. Reverse procedure.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


To replace the turn signal switch on a new Beetle, the old switch has to be removed and a new one plugged in. The turn signal switch or flasher is located under the dash just above the brake pedal.


turn signal switch is the hazard button! Pull out hazard button and replace it! good luck!


The 2003 Chevrolet Silverado turn signal switch is located below the dashboard, on the drivers side of the passenger compartment. The turn signal switch simply plugs in and out.


It's in the hazard warning switch. You need to replace the switch.



The turn signal switch is quite easy to remove and replace. The turn signal switch simply plugs in and plugs out.


It is quite simple to replace the turn signal switch on your 1990 Buick LeSabre. The turn signal switch simply plugs in and out.


You need to remove the steering wheel. The switch is located below the steering wheel.


The flasher is broken. It is located inside the hazard switch and easy to replace. The switch is about $30 from the dealership and takes 10 minutes to replace.



Replace ignition switch for 1993 buick century?


dimmer switch is on the turn signal lever, to replace you need to remove steering wheel


Visit http://www.likeabigdog.com/column/94upsignal.htm


How do I install a turn signal switch for a Chevy 2000 Impala? WHere is the old part that I need to replace?


My turn signal switch died on my 92 Grand Prix. Rather than attempting the repair, I took it to a shop. The steering column had to be removed to get to the switch.


The turn signal switch is part of the multifunction switch.The turn signal switch is part of the multifunction switch.


how to replace window toggle switch 1999 buick century


To replace a turn signal switch in a 1993 Chevy Lumina go to the trunk of the vehicle and find the plastic covering for the turn signal. Remove the cover and replace the bulb.


The turn signal switch is part of the multifunction switch.The turn signal switch is part of the multifunction switch.


To replace a turn signal switch on a 2003 Pontiac Aztek, also known as a flash relay, the steering column must be removed. The flash relay is located under the turn signal. Remove the mounting hardware and the unit can be taken off.


remove the steering column shouds and use a T20 torx screwdriver to take the two T/S switch mounting screws out and replace the switch.


When I use the signal it makes lot of noise


You will need to remove the turn signal switch retaining screws. The turn signal switch can then be pulled outward. Remove the wiring harness from the and of the turn signal switch. Reverse the process to install the new turn signal switch.


There is a very good step-by-step at this site: http://tss.likeabigdog.com/


Since the 92 Chevy Corsica is equipped with SRS (Saftey Restraint System), ie: Airbags, which is located in the steering wheel. In order to replace the turn signal switch you must remove the steering wheel. Therefore I would only highly advise you to take it to a dealer to have this done.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.